Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1905
$94.99
(You save)
Keep your front suspension tracking true with the Delphi control arm and ball joint assembly (TC1905), a front lower unit that drops in as a direct-fit replacement for the 2002-2012 Land Rover Range Rover. The control arm locates the wheel and links it to the chassis, while the integrated ball joint lets the suspension travel and the wheel steer. See the Buyer's Guide tab for engine-level fitment details.
OE-derived validation: tested to withstand temperatures below -40°C and over 120°C plus 720 hours of salt spray, with dimensional and material analysis for compatibility between the OE and aftermarket part.
100% inspected: crack detection and ultrasonic flaw detection to help materials match OE specifications.
Precision ball studs: machined to micron tolerances for durability and smooth joint operation.
Built consistent: robot welding for repeatable quality, with anti-corrosion protection applied to each part for corrosion prevention and enhanced aesthetics.
If a worn control arm or ball joint is behind your symptoms — clunking over the front end, wandering steering, or uneven tire wear — this assembly replaces it. Diagnose the cause before ordering. This listing is for one assembly.
It is a direct-fit replacement for the 2002-2012 Land Rover Range Rover. Check the Buyer's Guide tab to confirm the engine-level details for your specific vehicle.
Is this a front lower Range Rover control arm?
Yes. This assembly is cataloged as the front lower control arm and ball joint for the listed Range Rover applications.
What are the signs of a worn control arm or ball joint?
Common signs include clunking over the front end, wandering or loose steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
Does this Land Rover Range Rover control arm include the ball joint?
Yes. The ball joint is integrated into this control arm assembly, so you replace both together as a single unit.
How is this Delphi control arm tested?
Delphi validates it to OE performance: it withstands temperatures below -40°C and over 120°C, endures 720 hours of salt spray, and undergoes 100% crack and ultrasonic flaw detection.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1905
Locate the front wheel and manage suspension travel with the DELPHI control arm TC6664, a front right lower control arm and ball joint assembly that drops in as a direct-fit replacement for the...
Keep the rear wheels located and the suspension geometry tight with the Delphi control arm, MPN TC6869, a direct-fit replacement for the 2006-2010 Toyota RAV4. This rear control arm and ball joint...
Keep your front end tight and steering precise with the Delphi control arm and ball joint assembly (P/N TC6164), a direct-fit front upper unit for the 2003-2005 Dodge Ram 2500 and 2003-2005 Dodge Ram...
Tighten up a loose, clunking front end with the Delphi control arm TC5214, a front right lower suspension control arm and ball joint assembly that drops in as a direct-fit replacement for the...
Give your steering and suspension the geometry it was built with using the Delphi Suspension Control Arm and Ball Joint Assembly TC2929 — a Nissan Altima control arm that installs in the front right...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
