Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1666
Delphi TC2135 front left upper control arm with ball joint for the 2002-2005 Mercedes-Benz ML500 and other vehicles links the wheel carrier to the body. The ball joint pivots as the suspension moves, and as a control arm and ball joint assembly the arm and the joint are replaced as one unit.
A clunk over bumps, uneven tire wear or loose, wandering steering can mean the arm or its ball joint is worn. Before you replace this arm, rule out a worn strut, tie rod or wheel bearing, since those parts produce similar looseness and noise. This listing is one arm for the front left upper position; the 2002-2005 Mercedes-Benz ML500 takes one on this side, and the right side is ordered separately. Both sides are normally replaced together.
Vehicles it fits include the 2002-2005 Mercedes-Benz ML500, the 2003-2005 Mercedes-Benz ML350 and the 1998-2003 Mercedes-Benz ML320. If your Mercedes is not one of those, look up your own year and model in the "Vehicles it fits" section before you order.
Fit and size
Build and materials
Interchange: 101-6091 · 102-6091 · MB-H121 · 521-293 · 163 333 00 01 · A163 333 0001
KSC5418 · CB28037 · CB28037PR · CK80548 · K80548 · RK80548 · 163333001 · A163333001 · CMK80548 · GK80548 · MK80548
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right Mercedes ML350 control arm for the 2003-2005 model years?
Yes. Delphi TC2135 is a front left upper control arm with ball joint, and the 2003-2005 Mercedes-Benz ML350 is among the vehicles it fits.
How is this Delphi control arm tested?
Delphi TC2135 is tested below -40 degrees C and above 120 degrees C and exposed to 720 hours of salt spray. Each arm also gets 100% crack detection and ultrasonic flaw detection.
Which side and position does the TC2135 control arm go on?
Delphi TC2135 goes in the front left upper position. The right side is a separate part, so this listing is one arm only.
How can I tell if the ball joint on this arm is worn?
A knock over bumps, uneven tire wear or a steering wheel that wanders can mean the joint is worn. Have it inspected promptly, because a shop can test ball joint play safely.
How are the ball studs on this control arm made?
The ball studs are machined to micron tolerances for durability and smooth joint operation. The arm itself is robot-welded and has anti-corrosion protection applied.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.