Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6275
$124.99
(You save)
Keep your front suspension located precisely and your ball joint working smoothly with the DELPHI control arm (MPN TC6275), a front right lower control arm and ball joint assembly engineered as a direct-fit replacement for the 1995-2002 Mazda Millenia. It locates the wheel and controls suspension travel while the integrated ball joint allows the steering and suspension to pivot.
Tested to OE extremes: Delphi applies its OE engineering to its aftermarket steering line, with parts validated below -40°C and above 120°C and through 720 hours of salt spray, plus dimensional and material analysis for OE-to-aftermarket compatibility.
100% inspected: Every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: Studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: Robot welding delivers consistent quality, and an anti-corrosion coating is applied for corrosion prevention and improved appearance.
Clunking over bumps, wandering steering, or uneven tire wear can be signs the original arm or ball joint may need replacing. If a worn front right lower control arm or ball joint is the cause on your Mazda Millenia, this assembly replaces it.
This part cross-references / interchanges with the following part numbers:
102-7361, 520-828, TA04-34-300F, CMS76121
Frequently Asked Questions
What vehicles does the DELPHI TC6275 control arm fit?
It is a direct-fit replacement for the 1995-2002 Mazda Millenia. See the Buyer's Guide tab to confirm the fit for your specific vehicle.
What position is this Mazda Millenia control arm?
It is cataloged as the front right (passenger-side) lower control arm and ball joint assembly.
Does this control arm and ball joint assembly come with the ball joint installed?
Yes. The ball joint is integrated into this assembly, so the arm and ball joint replace as one unit.
How is the Delphi arm tested for quality?
Each arm gets 100% crack detection and ultrasonic flaw detection, ball studs machined to micron tolerances, and validation across extreme temperatures and 720 hours of salt spray.
What are signs I need to replace this control arm?
Clunking over bumps, wandering or loose steering, and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC6275
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Steer straight and keep the front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly (TC3986), a direct-fit Tacoma lower control arm for the 2016-2022 Toyota Tacoma. It...
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
