Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2718
$69.99
(You save)
Steady your steering and restore proper wheel location with the Delphi control arm and ball joint assembly, MPN TC2718. This is the front left lower unit, and it drops in as a direct-fit replacement for the 2011-2017 Hyundai Accent — a smart choice if you're hunting for a Hyundai Accent lower control arm with the ball joint already pressed in. The arm locates the wheel while the integrated ball joint allows the steering and suspension to pivot; worn bushings or a loose, notchy joint can cause clunking on acceleration or over bumps, uneven tire wear, and wandering steering.
OE-derived testing: Delphi validates these parts below -40°C and over 120°C, plus 720 hours of salt-spray exposure, with dimensional and material analysis for OE-matched compatibility.
Quality-controlled materials: 100% crack detection and ultrasonic flaw detection confirm materials match OE specifications.
Precision ball stud: studs are machined to micron tolerances for durability and smooth joint operation.
Robot welding & anti-corrosion: robotic welding for consistent quality, with anti-corrosion protection applied to each part.
See the Buyer's Guide tab for engine-level fitment.
Does this Delphi control arm fit my Hyundai Accent?
Yes. TC2718 is a direct-fit front left lower arm for the 2011-2017 Hyundai Accent. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
Is the ball joint included?
Yes. This is a control arm and ball joint assembly, so the ball joint comes pre-installed in the arm — you replace both the arm and joint as one unit.
Which position is this lower arm Hyundai Accent part?
It is the front left (driver-side) lower control arm. Order the matching right-side unit separately if you need both.
What signs mean I may need to replace it?
Clunking on acceleration or over bumps, uneven tire wear, and wandering steering can point to worn bushings or a failing ball joint. Diagnose the cause before replacing.
How is it protected against rust and wear?
Anti-corrosion protection is applied to each part, and Delphi validates these arms through 720 hours of salt-spray exposure along with temperature testing below -40°C and over 120°C.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2718
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
