Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2980
$69.99
(You save)
Help keep steering precise and handling stable with the Delphi control arm assembly TC2980, a direct-fit front lower forward replacement for the listed applications. It fits many BMW models, among them the 2009-2012 BMW 328I Xdrive, 2009-2012 BMW 335I Xdrive and 2012 BMW X1; see the Buyer's Guide tab for the full list. This control arm and ball joint assembly locates the front wheel and pivots the suspension; if a worn arm or a loose ball joint is the source of your clunking or wandering steering, this unit replaces both in one part.
OE-level testing: Built on Delphi's OE safety technology, it withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray, with dimensional and material analysis for close OE compatibility.
Verified integrity: Undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: Ball studs are machined to micron tolerances for durability and smooth joint operation.
Consistent build: Robot welding for repeatable quality, plus anti-corrosion protection for corrosion prevention and enhanced appearance.
Sold individually; replacing the matching side together is good practice for balanced handling. See the Buyer's Guide tab for engine details.
Yes — TC2980 is cataloged as the front lower forward control arm and ball joint assembly for the 2012 BMW X1, plus other BMW models. Check the Buyer's Guide tab for the full list.
What are the signs I need a 2012 BMW X1 lower control arm replacement?
Signs the front lower arm or its ball joint may need replacing include clunking over the front end during turns or braking, loose or wandering steering, and uneven front tire wear.
Is the ball joint included with this lower arm?
Yes. TC2980 ships as a complete assembly with the ball joint pre-installed, so you replace the arm and joint together as one unit.
Is this a direct-fit control arm?
It is a direct-fit front lower forward replacement for the listed applications. Verify your specific vehicle against the Buyer's Guide tab.
What quality checks does Delphi apply to this control arm?
Delphi applies 100% crack and ultrasonic flaw detection, machines the ball studs to micron tolerances, and uses robot welding plus anti-corrosion protection on each part.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2980
Help keep the front wheel properly located with the Delphi control arm and ball joint assembly (P/N: TC1666), a direct-fit front left upper unit for the 1989-1997 Ford Thunderbird and 1989-1997...
Help restore steady handling up front with the Delphi control arm — the Suspension Control Arm and Ball Joint Assembly TC5343. This front left upper control arm and ball joint assembly drops in as a...
Fit your Delphi control arm with confidence: the Delphi Suspension Control Arm and Ball Joint Assembly TC5428 mounts in the front right upper position and locates the wheel while the integrated ball...
Tighten up your front suspension with the DELPHI control arm TC6252, a Suspension Control Arm and Ball Joint Assembly that installs as the front right lower forward unit and drops in as a direct-fit...
Keep your front suspension located precisely and your ball joint working smoothly with the DELPHI control arm (MPN TC6275), a front right lower control arm and ball joint assembly engineered as a...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
