Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3314
$137.99
(You save)
Locate the front wheel and give the steering knuckle a smooth pivot with the Delphi control arm assembly TC3314, a front right lower control arm with an integrated ball joint for the 2007-2011 Mini Cooper. This single unit combines the lower control arm with its ball joint, allowing suspension travel while the joint lets the steering knuckle pivot. See the Buyer's Guide tab for the full engine-level application list.
OE-focused validation: tested to the extreme, with parts withstanding temperatures below -40°C and over 120°C plus 720 hours of salt spray; extensive dimensional and material analysis targets close OE-to-aftermarket compatibility.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: studs are machined to micron tolerances for durability and smooth joint operation.
Built for consistency: robot welding for repeatable quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
Worn signs this part may need replacing include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear. On 2007-2011 Mini Cooper control arm jobs, an alignment is recommended after installation.
What is the Delphi TC3314 control arm and ball joint assembly?
It's a front right lower control arm with an integrated ball joint that locates the wheel, allows suspension travel, and lets the steering knuckle pivot, sold as one assembly for the 2007-2011 Mini Cooper.
Does the TC3314 fit my 2007-2011 Mini Cooper?
It's a direct-fit replacement for the 2007-2011 Mini Cooper. Check the Buyer's Guide tab and confirm the front right lower position matches your vehicle before ordering.
How is the Delphi ball joint made for durability?
The ball studs are machined to micron tolerances for durability and smooth joint operation, and every arm undergoes crack and ultrasonic flaw detection so materials match OE specifications.
What are signs I need to replace this control arm?
Common signs include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
Should I get an alignment after installing it?
Yes, an alignment is recommended after replacing a control arm to set proper wheel angles and help prevent uneven tire wear.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3314
Help maintain precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position...
Help restore steering precision and confident wheel control with the Delphi control arm and ball joint assembly (P/N: TC5901), a direct-fit replacement for the front left upper position on the...
Steer with confidence and keep your front suspension tight with the Delphi control arm and ball joint assembly (P/N: TC6247). This is the front left upper unit, dropping in as a direct-fit...
Help keep your steering precise and your ride stable with the Delphi control arm and ball joint assembly (P/N: TC1393), a direct-fit replacement for the front right lower rearward position on the...
Help restore steady front-end control on your Audi with the Delphi control arm and ball joint assembly (TC2455) — a Delphi control arm that installs as a front right lower rearward, direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
