Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3444
$170.99
(You save)
Steer with confidence and settle the front end with the Delphi control arm — the TC3444 control arm and ball joint assembly for the front left lower rearward position. It's a direct-fit replacement for many vehicles, among them the 2010-2011 Audi A4, the 2010-2011 Audi A5 and the 2010-2011 Audi Q5 — see the Buyer's Guide tab for the full list of vehicles and engines.
This arm locates the wheel and, through its integrated ball joint, lets the wheel pivot for steering while the suspension travels. Signs the original may need replacing include clunking over bumps, loose or wandering steering, uneven front tire wear and visible play or torn bushings.
Tested to the extreme: withstands temperatures below -40°C and over 120°C plus 720 hours of salt spray, with dimensional and material analysis for OE-level compatibility.
Verified integrity: 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: machined to micron tolerances for durability and smooth joint operation.
Built consistent: robot welding for repeatable quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
Is this the right control arm for a 2010-2011 Audi Q5?
Yes. It's a direct-fit front left lower rearward replacement for the 2010-2011 Audi Q5 and many other Audi models. Check the Buyer's Guide tab to confirm your exact vehicle and engine.
What position is this control arm?
It is the front left lower rearward control arm, with its ball joint, for the listed applications.
Does it come with the ball joint installed?
Yes. The ball joint is integrated into the arm, so you replace the arm and joint together as one unit.
What are the signs this part may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven front tire wear, and visible play or torn bushings. Have the cause diagnosed before replacing, since other parts can produce similar symptoms.
Should I replace both sides at once?
This listing is for one assembly. Many technicians recommend inspecting and, if worn, replacing the matching side for balanced handling, but replace based on the condition of each part.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3444
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Bolt on a fresh DELPHI control arm and quiet down worn-out steering and suspension on your Volvo with the Delphi Suspension Control Arm and Ball Joint Assembly TC8934. This front right lower unit is...
Locate the front wheel and let the steering knuckle pivot with the Delphi control arm, MPN TC4942 — a front upper unit cataloged for the front left upper and front right upper positions. It installs...
Keep your BMW's front suspension tracking true with the DELPHI control arm and ball joint assembly (MPN TC4941), a front left upper unit that locates the wheel and lets it move through its travel...
Help bring stable, precise handling back to your BMW with the DELPHI control arm and ball joint assembly, part number TC8786. It installs in the front left upper position as a direct-fit replacement...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
