Delphi TC3832 control arm with ball joint for the 2016-2020 Audi A4 and other vehicles is the front right lower rearward arm, built with the ball joint attached. Listed as a control arm and ball joint assembly, it replaces both parts in one piece.
- Withstands temperatures below -40 degrees C and over 120 degrees C, and is exposed to 720 hours of salt spray in testing
- 100% crack detection and ultrasonic flaw detection, so materials match OE specifications
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Robot-welded for consistent performance and quality, with anti-corrosion protection applied to each part
A clunk over bumps, loose steering or uneven tire wear can mean a worn control arm or ball joint. Sway bar links, tie rods or a worn wheel bearing can be behind these signs too, so find the cause before buying. This listing is one piece for the front right, and both sides are normally replaced together. The 2016-2020 Audi A4 takes one of these.
It is also a direct-fit replacement for the 2018-2026 Audi A5 Quattro and the 2018-2025 Audi S4. If your car is not named here, open the Buyer's Guide tab and look up your exact model and engine.
Specifications
- Position: front right lower rearward
- Quantity per vehicle: 1
- Type: control arm with ball joint, sold individually
Interchange: 526-846 · 8W0 407 694 A · 8W0 407 694 B
KSC4272 · RK623825 · CMS701134 · X01CJ9994
This part cross-references / interchanges with the following part numbers:
8W0 407 694 A, 8W0 407 694 B, 526-846, KSC4272, RK623825, CMS701134, X01CJ9994
