Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5159
$63.99
(You save)
Keep your front suspension located and your steering knuckle pivoting smoothly with the Delphi control arm and ball joint assembly (TC5159) — a front upper unit that installs as a direct-fit replacement for the 2005-2010 Dodge Dakota, 2006-2009 Mitsubishi Raider, and 2011 Ram Dakota. It brings Delphi's OE safety expertise to the aftermarket steering portfolio in a single assembly.
Tested to the extreme: withstands temperatures below -40°C and over 120°C and 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
Flaw inspected: 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: machined to micron tolerances for durable, smooth joint operation.
Built consistent: robot-welded for repeatable quality, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
The arm locates the wheel and lets the integrated ball joint pivot as the suspension travels. Signs this control arm may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear — diagnose the cause before replacing. If you need a control arm for the 2005-2010 Dodge Dakota, this front upper assembly covers it along with the other listed applications in the Buyer's Guide tab.
Is this the right control arm for a 2005-2010 Dodge Dakota?
Yes. This front upper assembly is a direct-fit replacement for the 2005-2010 Dodge Dakota; see the Buyer's Guide tab for the other listed applications.
Is this a front upper or front lower control arm?
This is the front upper control arm for the listed applications.
Does the assembly include the ball joint?
Yes. The ball joint is integrated into the arm, so it installs as one unit.
What are the signs this control arm needs replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause before replacing.
What testing does this Delphi control arm receive?
Each part sees 100% crack and ultrasonic flaw detection, ball studs machined to micron tolerances, robot welding, plus temperature and 720-hour salt-spray testing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5159
Help maintain precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position...
Help restore steering precision and confident wheel control with the Delphi control arm and ball joint assembly (P/N: TC5901), a direct-fit replacement for the front left upper position on the...
Steer with confidence and keep your front suspension tight with the Delphi control arm and ball joint assembly (P/N: TC6247). This is the front left upper unit, dropping in as a direct-fit...
Help keep your steering precise and your ride stable with the Delphi control arm and ball joint assembly (P/N: TC1393), a direct-fit replacement for the front right lower rearward position on the...
Help restore steady front-end control on your Audi with the Delphi control arm and ball joint assembly (TC2455) — a Delphi control arm that installs as a front right lower rearward, direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
