Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5479
$103.99
(You save)
Help keep steering precise and suspension travel quiet with the Delphi control arm and ball joint assembly, part number TC5479. This front right upper unit drops in as a direct-fit replacement for the 2003-2004 Ford Expedition and 2003-2004 Lincoln Navigator, locating the wheel and pivoting through its integrated ball joint so the wheel can steer and move over the road. It draws on Delphi's OE engineering, applied to their aftermarket steering portfolio.
Built and tested to OE standards:
Extreme validation: withstands temperatures below -40°C and over 120°C, with 720 hours of salt-spray exposure; dimensional and material analysis targets close OE-to-aftermarket compatibility.
Inspected material: 100% crack detection and ultrasonic flaw detection help ensure materials match OE specifications.
Precision stud: ball studs machined to micron tolerances for durability and smooth joint operation.
Consistent build: robot welding for repeatable quality, plus anti-corrosion protection applied to each part for corrosion prevention and improved appearance.
Worn control arm bushings or a loose ball joint can show up as clunking over bumps, wandering steering, or uneven tire wear. If a failed front right upper control arm is the cause, this assembly replaces it. See the Buyer's Guide tab for engine details.
Is this Delphi TC5479 the right upper control arm for a 2003-2004 Ford Expedition?
Yes. TC5479 is the front right upper unit for the 2003-2004 Ford Expedition and 2003-2004 Lincoln Navigator.
What position does this Delphi control arm cover?
It is the front right upper unit. Check the Buyer's Guide tab to confirm it matches the position and application on your vehicle.
Is this the right control arm for a 2003-2004 Lincoln Navigator?
Yes, it is a direct-fit replacement for the 2003-2004 Lincoln Navigator front right upper position, as well as the 2003-2004 Ford Expedition.
What are signs this control arm may need replacing?
Common signs include clunking over bumps, wandering or loose steering, and uneven tire wear. Have the suspension diagnosed to confirm the cause before replacing.
Is the ball joint included with this control arm?
Yes. The ball joint is built into the control arm as a single integrated unit.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5479
Keep the rear wheels located and the suspension geometry tight with the Delphi control arm, MPN TC6869, a direct-fit replacement for the 2006-2010 Toyota RAV4. This rear control arm positions the...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Help keep your steering tight and your wheel located precisely with the Delphi control arm and ball joint assembly, MPN TC6562. This is the front left lower unit, engineered to drop into the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
