Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5770
$149.99
(You save)
Restore precise steering and secure suspension geometry with the Delphi Suspension Control Arm and Ball Joint Assembly (TC5770). This front right lower unit installs as a direct-fit replacement for the 2005-2010 Ford Mustang (see the Buyer's Guide tab for engine-level fitment), combining the control arm and its integrated ball joint into one assembly that locates the wheel and lets the suspension pivot through its travel. Worn control-arm bushings or a loose ball joint can cause clunking over the road, uneven tire wear, and imprecise steering — if the original arm or joint is the cause, this replaces it.
OE-derived engineering: Built on Delphi's OE expertise, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility. Tested to the extreme — withstands temperatures below -40°C and over 120°C and 720 hours of salt spray.
Verified materials: Undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: Ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: Robot welding gives consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics.
It's a direct-fit replacement for the 2005-2010 Ford Mustang. Check the Buyer's Guide tab for engine-level fitment details for your specific vehicle.
What position is this control arm assembly?
This is the front right lower control arm and ball joint assembly. Confirm the position needed for your vehicle before ordering.
What does this assembly do?
It combines the control arm and its integrated ball joint to locate the wheel and let the suspension pivot through its travel, helping maintain steering and suspension geometry.
What are signs the control arm or ball joint may need replacing?
Clunking over bumps, uneven tire wear, and imprecise or wandering steering can be signs. Have the cause diagnosed, since these symptoms can have other sources.
How is this Delphi part tested for durability?
It undergoes 100% crack detection and ultrasonic flaw detection, and is tested below -40°C, over 120°C, and through 720 hours of salt spray. Ball studs are machined to micron tolerances.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5770
Keep your steering tight and your ride controlled with the Delphi Suspension Control Arm and Ball Joint Assembly (TC1755), a front left upper unit that locates the wheel and pivots on an integrated...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
