Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5799
$69.99
(You save)
Keep your front wheel located and your steering precise with the Delphi Suspension Control Arm and Ball Joint Assembly TC5799 — the front right upper control arm for the 2003-2007 Infiniti G35 and 2003-2009 Nissan 350Z. This 350Z control arm positions the steering knuckle and lets the suspension travel while its integrated ball joint pivots to maintain alignment geometry. See the Buyer's Guide tab for engine-level fitment.
OE-grade validation: tested to the extreme — withstands temperatures below -40°C and over 120°C plus 720 hours of salt-spray exposure, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Inspected materials: every arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded & protected: robotic welding delivers consistent quality, and an anti-corrosion protective finish is applied to each part.
As a Delphi control arm, this G35 control arm draws on Delphi's OE steering expertise. Signs the original may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. Sold individually — replace as directed by the vehicle service procedure.
Does this Infiniti G35 control arm fit my vehicle?
It is the front right upper control arm for the 2003-2007 Infiniti G35 and 2003-2009 Nissan 350Z. Check the Buyer's Guide tab to confirm your exact vehicle.
What is a control arm and ball joint assembly?
It is a suspension arm with an integrated ball joint that locates the wheel and steering knuckle, allowing suspension travel while the pivoting ball joint helps maintain alignment geometry.
Is the ball joint included with this control arm?
Yes. The ball joint is integrated into this assembly, so it installs together as one unit rather than requiring a separate ball joint.
What are signs this part may need replacing?
Common signs include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. Have the cause diagnosed, since these symptoms can have other sources.
Is this a genuine Delphi control arm?
Yes, it is a Delphi TC5799 assembly. Delphi applies its OE steering expertise, with 100% crack and ultrasonic flaw detection and ball studs machined to micron tolerances.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5799
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Steer straight and keep the front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly (TC3986), a direct-fit Tacoma lower control arm for the 2016-2022 Toyota Tacoma. It...
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
