Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1075
Help keep steering precise and the wheel securely located with the Delphi control arm TC6380, a front right upper suspension control arm and ball joint assembly that installs as a direct-fit replacement for the listed applications. It fits many vehicles, among them the 1995-2000 Ford Explorer, 1998-2011 Ford Ranger and 1998-2010 Mazda B4000; see the "Vehicles it fits" section for the full list. If you need a 1995-2000 Ford Explorer control arm to address clunks or loose steering, this pre-assembled unit locates the wheel and lets it pivot through its travel.
Because the ball joint is integrated, you replace the arm and joint together in one bolt-in unit. Sold individually as the front right upper arm; consult the vehicle service information for the correct fasteners and whether they may be reused, and have your suspension aligned after installation.
Interchange: 623.65058 · 520-222 · 3L5Z 3084-AA · 6L5Z 3084-AA · 8L5Z 3084-R
62365058 · 520222 · 3L5Z3084AA · 6L5Z3084AA · 8L5Z3084R · MCSOE9 · CB80068 · CB80068PR · CK622993 · CK80068 · RK80068 · CMK80068 · CTXK80068 · GK80068 · JTC1584
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What is the Delphi TC6380?
It's a front right upper control arm with an integrated ball joint, supplied together as one bolt-in unit for the listed applications.
Is this the right Ford Ranger control arm for a 1998-2011 Ford Ranger?
Yes, it is listed for the 1998-2011 Ford Ranger, and it also fits the 1995-2000 Ford Explorer and 1998-2010 Mazda B4000. See the "Vehicles it fits" section for the full list.
Is this an upper or lower control arm?
It's the front right upper arm. It will not replace a lower arm or the left-side upper arm.
Does the ball joint come already installed?
Yes. The ball joint is integrated into the assembly, so you install the arm and joint together as one pre-assembled unit with no separate press-in ball joint needed.
What are signs the control arm or ball joint may need replacing?
Clunking or knocking over bumps, wandering or loose steering, and uneven front tire wear can be signs. Have the suspension diagnosed, since these symptoms can have other causes.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.