Delphi TC7182 rear right upper control arm with ball joint for the 1996-2003 Toyota RAV4 connects the rear right wheel to the body and lets the suspension move. Also called a control arm and ball joint assembly, it replaces the arm and its ball joint as one unit.
- 100% crack detection and ultrasonic flaw detection on each control arm
- Ball studs machined to micron tolerances for durable, smooth joint operation
- Robot welding for consistent performance and quality
- Anti-corrosion protection applied to each part
- Withstands temperatures below -40 degrees C and over 120 degrees C; parts are exposed to 720 hours of salt spray
Quick facts
- Part: Delphi TC7182 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: the 1996-2003 Toyota RAV4
- Position: Rear right upper
- Condition: New
A worn control arm or ball joint can show up as a clunk over bumps, uneven tire wear or loose handling. A worn shock absorber can make a similar noise, so these signs alone do not prove this arm is at fault.
Fits
This is a direct-fit replacement for the 1996-2003 Toyota RAV4, which takes one arm in this rear right upper position. The listing is a single arm; the left side of the rear axle is a separate part and is normally done at the same time.
Specifications
Fit and size
- Position: Rear right upper
- Quantity per vehicle: 1
Build and materials
- Type: control arm with ball joint
- Construction: robot-welded
- Finish: anti-corrosion protection
- Condition: New
Interchange: 102-6583 · 52-1694 · 48770-42010
CB74538 · CB74538PR · RK621735 · CMS86166 · GS86166
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
102-6583, 52-1694, CB74538, CB74538PR, RK621735, CMS86166, GS86166, 48770-42010
Frequently Asked Questions
Does the Delphi TC7182 control arm fit the 1996-2003 Toyota RAV4?
Yes. Delphi TC7182 is a rear right upper control arm with ball joint for the 1996-2003 Toyota RAV4, and that car takes one in this position.
Do I need to buy a ball joint separately with the TC7182 arm?
No. This part is a control arm with ball joint, so the joint is already part of the arm.
Is the Delphi TC7182 control arm robot-welded?
Yes. Delphi TC7182 uses robot welding for consistent performance and quality, and its ball studs are machined to micron tolerances.
How do I tell if the ball joint on a rear upper control arm is worn?
A clunk over bumps, uneven tire wear or loose handling can be signs. Have a shop inspect the suspension, since a proper ball joint check can need the vehicle raised.
Is the Delphi TC7182 protected against rust?
Yes. Anti-corrosion protection is applied to each part, and Delphi parts are exposed to 720 hours of salt spray in testing.
