Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7355
$130.99
(You save)
Locate and support the front-left corner of your Lexus with this Delphi control arm and integrated ball joint, MPN TC7355. It installs as a direct-fit replacement for the front left upper forward position on the 2007-2013 Lexus LS460 and 2008-2013 Lexus LS600h. If a worn control arm is the cause of loose steering, uneven tire wear, or clunking over bumps and when turning, this assembly replaces it.
OE-grade validation: built with Delphi's OE expertise and put through dimensional and material analysis for close compatibility with the original part; tested below -40°C and above 120°C and through 720 hours of salt spray.
Inspected materials: every control arm gets 100% crack detection and ultrasonic flaw detection so the materials match OE specifications.
Precision ball stud: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded, corrosion-protected: robot welding delivers consistent quality, and anti-corrosion protection is applied for corrosion prevention and enhanced appearance.
Sold as a control arm and ball joint assembly, so the ball joint arrives pre-installed in the arm. Because suspension parts wear in pairs, inspect the opposite-side arm and replace both if needed for balanced handling. See the Buyer's Guide tab for full fitment details.
Does this Delphi assembly fit my 2007-2013 Lexus LS460?
Yes — TC7355 is a direct-fit replacement for the front left upper forward position on the 2007-2013 Lexus LS460 and 2008-2013 Lexus LS600h. See the Buyer's Guide tab for full fitment details.
Is the ball joint included?
Yes. This assembly comes with the ball joint pre-installed in the arm — no separate ball joint is required.
Where does this control arm mount?
It fits the front left upper forward position. Because suspension wears in pairs, inspect the opposite side and replace both if worn for balanced, even handling.
What are the signs this control arm may need replacing?
Loose or wandering steering, uneven tire wear, and clunking or knocking over bumps or when turning can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
How is this Delphi part built?
It uses robot welding, ball studs machined to micron tolerances, 100% crack and ultrasonic flaw detection, and anti-corrosion protection, and is tested through 720 hours of salt spray.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7355
Help bring precise steering geometry and a solid front end back to your Audi or Volkswagen with the Delphi control arm and integrated ball joint, MPN TC1343. This front lower forward assembly locates...
Steer with confidence and help restore proper suspension geometry with the Delphi control arm and ball joint assembly, MPN TC2230. This is the front right lower rearward unit, and it drops in as a...
Connect the front suspension to the chassis and give the wheel a proper pivot point with this Delphi control arm with ball joint, part number TC1755, built for the front left upper position. It fits...
Help keep steering precise and wheel control steady with the Delphi control arm, part number TC1482 — a front right lower rearward suspension control arm and ball joint assembly that installs as a...
Keep the rear suspension properly located with the Delphi control arm TC1342, a control arm with ball joint that connects the wheel to the chassis and lets the suspension pivot as designed. It fits...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
