Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7632
$137.99
(You save)
The Delphi control arm and ball joint assembly, MPN TC7632, locates the front wheel and pivots the suspension through its integrated ball joint. It installs as a direct-fit replacement in the front right lower position for the 2015-2017 Hyundai Sonata, 2016-2021 Hyundai Tucson, 2016-2020 Kia Optima and 2016-2022 Kia Sportage — see the Buyer's Guide tab for engine-level fitment. Shopping a Hyundai Sonata lower control arm or a Kia Optima control arm? This unit combines both wear items in one assembly.
OE-focused validation: Delphi tests to extremes — parts withstand temperatures below -40°C and above 120°C and endure 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
Inspected materials: Each control arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: Ball studs are machined to micron tolerances for durable, smooth joint operation.
Robot-welded & coated: Robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.
Worn control arm bushings or a loose ball joint can cause clunking over bumps, wandering steering or uneven tire wear; if the assembly is the cause, this replaces it. Sold individually.
Which vehicles does the Delphi TC7632 control arm and ball joint assembly fit?
It's a direct-fit replacement for the 2015-2017 Hyundai Sonata, 2016-2021 Hyundai Tucson, 2016-2020 Kia Optima and 2016-2022 Kia Sportage. Check the Buyer's Guide tab for engine-level fitment.
What position does this assembly install in?
It's cataloged for the front right lower position. Confirm the side and location needed for your vehicle before ordering.
Is the ball joint included with this control arm?
Yes. This is a control arm and ball joint assembly, so the ball joint comes pre-installed as part of the unit.
What are signs this Hyundai Sonata control arm may need replacing?
Clunking over bumps, wandering or loose steering, and uneven tire wear can point to worn bushings or a loose ball joint. Diagnose the cause before replacing.
Does one listing cover both sides?
No. It's sold individually for the front right lower position; order the matching part for the other side if you also need it.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7632
Restore precise front-end geometry with the Delphi control arm and ball joint assembly, part number TC1708. This front right upper unit is a direct-fit replacement for the listed applications,...
Keep your front suspension located and your steering geometry tight with the Delphi control arm, MPN TC2044 — a front right upper forward control arm and ball joint assembly built with Delphi's OE...
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
