Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7800
$140.99
(You save)
Help keep steering precise and the wheel solidly located with the Delphi control arm — the TC7800 control arm and ball joint assembly. It drops in as a direct-fit front left lower replacement for the 2014-2020 Mazda 6 and 2013-2016 Mazda CX-5 (all engines), locating the wheel and letting it pivot and travel while the integrated ball joint allows steering movement.
Tested to OE extremes: validated below -40°C and above 120°C with 720 hours of salt-spray exposure, plus dimensional and material analysis for OE-matched fit.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Micron-machined ball studs: the ball studs are machined to micron tolerances for durability and smooth joint operation.
Robot-welded, corrosion-protected: robot welding delivers consistent quality, and anti-corrosion protection is applied to each part.
Delphi applies its OE safety expertise to its aftermarket steering line, so this replacement is built to closely match the original part. If a worn control arm or ball joint is behind clunking over bumps, wandering steering, or uneven tire wear, this assembly replaces both components in one unit. Country of origin: Turkey.
It is a direct-fit front left lower control arm with ball joint for the 2014-2020 Mazda 6 and the 2013-2016 Mazda CX-5, all engines. Check the Buyer's Guide tab to confirm your vehicle.
Does this assembly include the ball joint?
Yes. The TC7800 is a control arm with an integrated ball joint, so it installs as one unit.
What are signs my control arm or ball joint may need replacing?
Clunking over bumps, wandering or loose steering, vibration, and uneven tire wear can point to a worn control arm or ball joint. Diagnose the cause first, since these signs can have other sources.
Where is the Delphi TC7800 made?
Country of origin: Turkey. It is part of Delphi's aftermarket steering portfolio, built using the company's OE testing and inspection processes.
What should I check before buying the TC7800?
Confirm in the Buyer's Guide tab that the front left lower position is the one you need; the TC7800 is 100% inspected with crack and ultrasonic flaw detection to match OE specifications.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7800
Help bring precise steering geometry and a solid front end back to your Audi or Volkswagen with the Delphi control arm and integrated ball joint, MPN TC1343. This front lower forward assembly locates...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Help keep steering precise and wheel control steady with the Delphi control arm, part number TC1482 — a front right lower rearward suspension control arm and ball joint assembly that installs as a...
Connect the front suspension to the chassis and give the wheel a proper pivot point with this Delphi control arm with ball joint, part number TC1755, built for the front left upper position. It fits...
Help keep your steering tight and your front suspension planted with the Delphi Suspension Control Arm and Ball Joint Assembly TC5928 — a direct-fit 1998-2001 Nissan Altima control arm that locates...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
