Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1666
Connect the front wheel to the chassis and give the steering a smooth pivot point with the Delphi control arm TC1383, a suspension control arm with ball joint for the front left lower rearward position. It is listed for many models from one make, among them the 2007-2010 Mercedes-Benz CLS550, 2007-2010 Mercedes-Benz CLS63 AMG and 2003-2009 Mercedes-Benz E320, and it is a direct-fit replacement for the listed applications. See the Buyer's Guide tab for the full list and engine details.
Delphi's OE safety technology is fitted to millions of vehicles worldwide, and Delphi brings that OE expertise to its aftermarket steering range. Parts are tested at temperatures below -40°C and above 120°C and exposed to 720 hours of salt spray. Delphi's extensive dimensional and material analysis is aimed at close compatibility between the OE and aftermarket part.
Signs this part may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear and play in the ball joint. Other suspension parts can cause similar symptoms, so diagnose the cause before replacing.
Interchange: 101-6151 · 102-6151 · MB-H223 · 520-951 · 211 330 81 07 · 211 330 91 07 · A211 330 8107 · A211 330 9107
1016151 · 1026151 · MBH223 · 520951 · 2113308107 · 2113309107 · A2113308107 · A2113309107 · KSC5439 · CA28143 · CA28203 · CK620187 · RK620187 · CMS10143 · GS10143 · MS10143 · JTC1158
This part cross-references / interchanges with the following part numbers:
Will this Mercedes E320 control arm fit my car?
Delphi TC1383 is listed for the 2003-2009 Mercedes-Benz E320 and the 2007-2010 Mercedes-Benz CLS550 and CLS63 AMG. Check the Buyer's Guide tab to confirm your exact vehicle.
What does a control arm and ball joint assembly do?
It links the wheel end to the vehicle's chassis so the suspension can move, while the ball joint provides a pivot for steering. TC1383 fits the front left lower rearward position.
How does Delphi test these parts?
Each control arm goes through 100% crack detection and ultrasonic flaw detection. Parts are tested at temperatures below -40°C and above 120°C and exposed to 720 hours of salt spray.
What should I know about installation?
Consult the vehicle service information for the correct fasteners, torque values and whether the original fasteners may be reused. A wheel alignment check after installation is recommended.
What are signs a lower control arm may need replacing?
Clunking over bumps, loose or wandering steering, uneven tire wear or play in the ball joint may point to a worn arm. Diagnose the cause first, because other suspension parts can cause similar signs.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.