Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8135
$107.99
(You save)
Replace a worn front right lower arm with the Delphi control arm TC8135, a control arm and ball joint assembly that connects the suspension to the steering knuckle so the wheel can travel over the road and pivot as you steer. It fits many vehicles, among them the 2002-2006 Toyota Camry, 2004-2007 Toyota Highlander and 2004-2008 Toyota Solara. See the Buyer's Guide tab for the full list and engine details.
Delphi brings the OE safety technology fitted to millions of vehicles worldwide to its aftermarket steering line. Its dimensional and material analysis is aimed at close compatibility between the OE part and this replacement.
Tested to extremes: built to withstand temperatures below -40°C and above 120°C, and exposed to 720 hours of salt spray.
Flaw inspection: every control arm goes through 100% crack detection and ultrasonic flaw detection to check that its materials match OE specifications.
Precision ball stud: ball studs are machined to micron tolerances, designed for durability and smooth joint operation.
Robot welding and corrosion protection: robot welding supports consistent performance and quality, and anti-corrosion protection is applied to each part to help prevent corrosion and improve appearance.
Signs this part may need replacing include clunking or knocking over bumps, loose or wandering steering, and uneven tire wear. These symptoms can have other causes, so diagnose the suspension before replacing parts. A wheel alignment is recommended after installation.
Frequently Asked Questions
Will this Toyota Camry control arm fit my 2004 Camry?
Yes. The Delphi TC8135 is listed for the 2002-2006 Toyota Camry in the front right lower position. See the Buyer's Guide tab for engine details.
Can I use it as a Toyota Highlander control arm too?
Yes. It is also listed for the 2004-2007 Toyota Highlander and the 2004-2008 Toyota Solara. Other listed vehicles are in the Buyer's Guide tab.
What does this control arm with ball joint do?
It connects the suspension to the steering knuckle, letting the wheel move up and down and pivot for steering. The ball joint is built into the arm, so both are replaced as one unit.
Which position does the Delphi TC8135 fit?
It is the front right lower control arm. The front left lower arm is a separate part.
What are signs of a worn control arm or ball joint?
Common signs include clunking over bumps, loose or wandering steering, and uneven tire wear. Diagnose the cause before replacing parts, and have the alignment checked after installation.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8135
Help bring back a steady, connected feel to the front end by replacing a worn Honda Civic control arm with the Delphi TC1075, a front right upper control arm with ball joint that installs as a...
Keep your front suspension linked to the chassis with the Delphi control arm TC1043, a front left upper control arm and ball joint assembly whose built-in ball joint lets the wheel pivot for steering...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Keep the front wheel properly located as the suspension travels with the Delphi control arm TC5439, a front left upper control arm with ball joint that pairs both parts in one unit. It fits many...
Refresh worn rear suspension with the Delphi control arm assembly TC5994, a rear lower forward control arm and ball joint assembly that drops in as a direct-fit replacement for the 2006-2012 Hyundai...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
