Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC9472
$167.99
(You save)
Keep your steering tight and your front suspension located precisely with the DELPHI control arm assembly TC9472, a front right lower rearward control arm and ball joint assembly that drops in for the 2009-2012 Lexus LS460 and 2008-2013 Lexus LS600H. It helps support and locate the front suspension while the integrated ball joint allows the steering and suspension to articulate smoothly. See the Buyer's Guide tab for the full engine-level fitment.
Machined ball studs: the ball studs are machined to micron tolerances for durable, smooth joint operation.
Robot-welded: control arms use robot welding for consistent performance and quality.
Inspected to OE: each arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced aesthetics.
Delphi applies its OE expertise to this aftermarket steering portfolio, testing to the extreme: parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility. If a worn or failed original is behind clunking on acceleration or braking, loose steering, or uneven tire wear on your Lexus LS460, this replaces it.
This part cross-references / interchanges with the following part numbers:
1028223, 48660-59015, 48660-59016
Frequently Asked Questions
What position is this DELPHI control arm?
It is the front right lower rearward control arm and ball joint assembly for the listed Lexus applications. Confirm it matches the corner you are replacing.
Which vehicles does the LS460 control arm TC9472 fit?
It fits the 2009-2012 Lexus LS460 and 2008-2013 Lexus LS600H. See the Buyer's Guide tab for the full engine-level fitment for your vehicle.
Is this a complete control arm and ball joint assembly?
Yes. The ball joint is integrated into the arm, so you replace both together as one assembly rather than pressing in a separate joint.
What interchange numbers does it replace?
It replaces 48660-59015, 48660-59016 and 1028223. Cross-referencing your original part number helps confirm the correct fit.
What are signs this control arm may need replacing?
Clunking on acceleration, braking or over bumps, loose or wandering steering, and uneven front tire wear can indicate a worn arm or ball joint. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC9472
Keep your front suspension located and your steering geometry tight with the Delphi control arm, MPN TC2044 — a front right upper forward control arm and ball joint assembly built with Delphi's OE...
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
