Keep the front lower control arm located and cushioned with the Delphi Suspension Control Arm Bushing TD1247W, the front lower rearward bushing that isolates road vibration and helps limit unwanted movement in the suspension. It installs as a direct-fit replacement for the 2003-2010 Audi A8 Quattro, the 2003 Audi S8, and the 2004-2006 Volkswagen Phaeton — see the Buyer's Guide tab for engine-level details.
- Built to OE standards: Delphi applies its OE steering and suspension expertise to the aftermarket, with dimensional and material analysis for close compatibility between the OE and aftermarket part.
- Tested to the extreme: withstands temperatures below -40°C and above 120°C and endures 720 hours of salt spray.
- Quieter, smoother ride: manufactured for consistent life, to reduce noise, and to reduce vibration.
- Complete job: includes the necessary accessories.
Worn control arm bushings can show up as clunking on acceleration or over bumps, imprecise handling, or cracked and separated rubber — signs this bushing may need replacing. If a failed bushing is the cause, this Delphi unit restores proper location and cushioning at the front lower rearward position.
Interchange: 4E0 407 183 H
4E0407183H
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What is the Delphi TD1247W?
It is a Delphi Suspension Control Arm Bushing that mounts at the front lower rearward position to locate the control arm and isolate road vibration and noise.
Which vehicles does this bushing fit?
It is a direct-fit replacement for the 2003-2010 Audi A8 Quattro, the 2003 Audi S8, and the 2004-2006 Volkswagen Phaeton. See the Buyer's Guide tab for engine-level details.
What number does it interchange with?
It cross-references 4E0 407 183 H (also listed as 4E0407183H).
What are signs my control arm bushing needs replacing?
Watch for clunking on acceleration or over bumps, imprecise handling, or cracked and separated rubber. Diagnose the cause before replacing, as other suspension parts can produce similar symptoms.
Is Delphi TD1247W built to OE standards?
Yes. It is designed to OE standards with dimensional and material analysis, tested below -40°C and above 120°C, and exposed to 720 hours of salt spray.
Write a Review