Built to reduce noise and vibration where the control arm pivots, the Delphi Control Arm Bushing, part number TD1500W, is designed to OE standards. It is a direct-fit replacement for the 2005-2009 Land Rover LR3 and 2010-2011 Land Rover LR4, cataloged for the rear upper rearward position.
A control arm bushing cushions the joint between the control arm and its mounting point. It lets the arm pivot as the suspension moves and helps isolate road vibration. Delphi's OE safety technology is fitted to millions of vehicles worldwide, and the company applies that OE expertise to its aftermarket steering portfolio.
- Designed to OE standards: Delphi bushings are built to OE standards, supported by extensive dimensional and material analysis of the OE and aftermarket part.
- Tested to the extreme: Delphi tests its parts at temperatures below -40°C and above 120°C and exposes them to 720 hours of salt spray.
- Consistent life, less noise: The bushing is manufactured for consistent life and to reduce noise.
- Reduced vibration: Delphi bushings are also manufactured to reduce vibration.
Signs that a suspension control arm bushing may need replacing include clunking or knocking over bumps, a loose or wandering feel, uneven tire wear, and visibly cracked or torn bushing material. Have the suspension inspected to confirm the cause before replacing parts.
Interchange: LR0 51616 · RGX 500121
MS104113 · JBU759 · LR051616 · RGX500121
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
MS104113, LR0 51616, RGX 500121, JBU759
Frequently Asked Questions
Is this the right 2005-2009 Land Rover LR3 control arm bushing?
It is listed for the rear upper rearward position on the 2005-2009 Land Rover LR3 and the 2010-2011 Land Rover LR4. Check the "Vehicles it fits" section to confirm your vehicle.
What does a control arm bushing do?
It cushions the connection between the control arm and its mounting point. It lets the arm pivot as the suspension moves and helps isolate noise and vibration.
What testing do Delphi parts go through?
Delphi tests its parts at temperatures below -40°C and above 120°C and exposes them to 720 hours of salt spray.
What are signs of a worn control arm bushing?
Common signs include clunking over bumps, a loose or wandering feel, uneven tire wear, and cracked or torn bushing material. Diagnose the cause before replacing parts.
What part numbers does the Delphi TD1500W cross-reference?
It cross-references LR0 51616, RGX 500121, MS104113 and JBU759.
