Quiet the clunks and keep the rear suspension located precisely with the Delphi Suspension Control Arm Bushing (TD1692W), a rear upper bushing that cushions the connection between the control arm and its mounting point. It's a direct-fit replacement for the 2012-2015 Hyundai Santa Fe, 2013-2014 Hyundai Santa Fe Sport, 2013-2015 Hyundai Santa Fe XL, 2010-2015 Hyundai Tucson, 2014-2015 Kia Sorento, and 2010-2016 Kia Sportage — see the Buyer's Guide tab for engine details.
- Built to OE standards: Delphi applies its OE steering and suspension expertise to the aftermarket, with dimensional and material analysis aimed at close OE-to-aftermarket compatibility.
- Tested to the extreme: validated below -40°C and above 120°C and subjected to 720 hours of salt spray.
- Refined ride: manufactured for consistent life, and designed to help reduce noise and vibration.
- Complete job: includes the necessary accessories for the installation.
Worn control arm bushings can show up as clunking on acceleration, deceleration, or over uneven roads, and as looseness or vibration from the rear suspension. If a failed bushing is the cause, replacing it with this Delphi unit restores a properly located, cushioned pivot.
Interchange: 55118-2S000
551182S000 · BCK63740 · BCK63740PR · MS90471
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this bushing do?
It cushions and locates the rear upper control arm at its mounting point, isolating vibration and helping limit unwanted movement in the suspension.
Which vehicles does the TD1692W fit?
It fits the 2012-2015 Hyundai Santa Fe, 2013-2014 Santa Fe Sport, 2013-2015 Santa Fe XL, 2010-2015 Tucson, 2014-2015 Kia Sorento, and 2010-2016 Kia Sportage. See the Buyer's Guide tab.
What are signs my control arm bushing may need replacing?
Clunking on acceleration, deceleration, or over bumps, plus looseness or vibration from the suspension. Diagnose the cause before replacing, since other parts can produce similar symptoms.
Are accessories included?
Delphi states it includes the necessary accessories for the job. Consult the vehicle service information for any additional fasteners and whether they may be reused.
Has this part been durability tested?
Delphi validates it below -40°C and above 120°C, with 720 hours of salt spray exposure, and uses dimensional and material analysis for close OE-to-aftermarket compatibility.
Write a Review