Delphi Suspension Control Arm Bushing P/N:TD1759W

Looking for a BMW 328i control arm bushing that seats properly and stays put? The Delphi Suspension Control Arm Bushing TD1759W is cataloged as the front lower forward arm-to-frame bushing and drops in as a direct-fit replacement for the 2012-2013 BMW 328I and 335I, the 2013 BMW 320I, and the 2013 BMW ActiveHybrid 3. It cushions the joint where the front lower control arm mounts to the frame, helping isolate road vibration while keeping the arm located.

• OE-standard design: Delphi bushings are designed to OE standards, drawing on the OE safety technology fitted to millions of vehicles worldwide.
• Tested to the extreme: validated below -40°C and above 120°C and through 720 hours of salt spray, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
• Built to reduce noise and vibration: manufactured for consistent life while helping cut noise and vibration.
• Accessories included: Delphi includes the necessary accessories for a complete job.

Signs a control arm bushing may need replacing include clunking over bumps, added vibration, and vague or wandering steering with uneven tire wear. If a worn front bushing is the cause, this Delphi replacement restores the factory mounting point. Diagnose the cause before replacing.

Interchange: 31 12 6 851 255 · 31 12 6 851 261 · 31 12 6 855 743 · 533-640
31126851255 · 31126851261 · 31126855743 · 533640 · MS10483 · X05BU0009