Cushion the connection between the rear lower control arm and the chassis with the Delphi Suspension Control Arm Bushing TD213W. Positioned at the rear lower rearward (and rear lower outer rearward) location, this bushing locates the control arm, allows controlled suspension movement, and helps isolate road vibration. It's a direct-fit replacement for a wide range of Mercedes-Benz models, including the 1984-1989 Mercedes-Benz 190E, 1986-1993 Mercedes-Benz 300E and 1994-2000 Mercedes-Benz C280. See the "Vehicles it fits" section for the full list.
Delphi applies its OE expertise to this aftermarket bushing:
- OE-standard design: engineered to Delphi's OE standards, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
- Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
- Reduced noise and vibration: built for consistent life while helping reduce noise and vibration.
- Complete job: includes the necessary accessories for the installation.
If worn, cracked, or separated bushings are the cause of clunking, vibration, or imprecise handling, replacing them can address it.
Interchange: 101-5814 · 602.34008 · MB-G606 · 201 352 00 27 · 220 352 02 27 · 230 352 00 27 · A201 352 0027 · A220 352 0227 · A230 352 0027
1015814 · 60234008 · MBG606 · 2013520027 · 2203520227 · 2303520027 · A2013520027 · A2203520227 · A2303520027 · BU05068 · BB28505 · K200082 · FB882 · GS25139 · MS10454 · JBU167
This part cross-references / interchanges with the following part numbers:
101-5814, 602.34008, MB-G606, BU05068, BB28505, K200082, FB882, 201 352 00 27, 220 352 02 27, 230 352 00 27, A201 352 0027, A220 352 0227, A230 352 0027, GS25139, MS10454, JBU167
Frequently Asked Questions
What does this control arm bushing do?
It cushions and locates the control arm where it mounts to the chassis, allowing controlled suspension movement while helping isolate road vibration and noise.
Where is the TD213W bushing located?
The catalog lists it in the rear lower rearward and rear lower outer rearward positions of the suspension.
What are signs the bushing may need replacing?
Clunking or knocking, vibration, imprecise handling, or uneven tire wear can be signs of worn, cracked, or separated bushings. Have the cause diagnosed before replacing.
Does it include installation accessories?
Yes. Delphi states this bushing includes the necessary accessories for a complete job.
How was this Delphi bushing tested?
Delphi validates it below -40°C and above 120°C and exposes it to 720 hours of salt spray, with dimensional and material analysis for OE compatibility.
