Delphi TD4225W rear upper control arm bushing for the 1993-2002 Cadillac Eldorado and other vehicles cushions the control arm's pivot at the knuckle. It is designed to OE standards.
- Built for consistent service life and reduced noise
- Manufactured to reduce vibration
- Tested at temperatures below -40 degrees C and over 120 degrees C
- Exposed to 720 hours of salt spray in testing
Quick facts
- Part: Delphi TD4225W control arm bushing
- Also called: suspension control arm bushing
- Fits: 1993-2002 Cadillac Eldorado and other vehicles
- Position: Rear at knuckle (upper)
- Condition: New
Cracked or split rubber, a clunk over bumps or looser-feeling handling can be signs of a worn bushing. A worn ball joint, strut or sway bar link can be behind those signs too, so sort out which part is at fault before you buy.
Fits
It is listed for a wide range of Cadillac models, including the 1993-2002 Eldorado, the 1994-1999 DeVille and the 1993-1997 Seville, and each takes two. This listing is one bushing; the one on the other side of the rear axle is normally replaced at the same time. If your Cadillac is not one of those three, look up your model and year in the "Vehicles it fits" section.
Specifications
- Position: Rear at knuckle (upper)
- Quantity per vehicle: 2
- Condition: New
Interchange: 905-504
18026757 · 18026758 · 18026759 · 18026760 · 18060684 · 18060685 · BKK90570 · BKK90570PR · K200174 · K200175 · GS50424 · MS50424 · JBU989
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
905-504, 18026757, 18026758, 18026759, 18026760, 18060684, 18060685, BKK90570, BKK90570PR, K200174, K200175, GS50424, MS50424, JBU989
Frequently Asked Questions
Will Delphi TD4225W fit a 1993-1997 Cadillac Seville?
Yes. Delphi TD4225W is listed for the 1993-1997 Cadillac Seville, which takes two. For another Cadillac, look up your model and year in the "Vehicles it fits" section.
Is this suspension control arm bushing for the upper or lower rear position?
It is for the upper position at the rear knuckle. Delphi TD4225W is listed for the rear at knuckle (upper) position.
How is this Delphi bushing tested?
Delphi tests its parts at temperatures below -40 degrees C and over 120 degrees C, and exposes them to 720 hours of salt spray.
What does a worn control arm bushing sound like?
A clunk over bumps, vibration through the floor or steering, or looser handling can be signs of a worn bushing. A shop can inspect the arm and bushing safely.
Is 905-504 a number Delphi TD4225W replaces?
Yes. 905-504 is one of the other numbers this bushing replaces, along with K200174 and JBU989.
