Delphi Suspension Control Arm Bushing P/N:TD586W
Help quiet a knocking front end and keep the wheel located precisely with the Delphi Suspension Control Arm Bushing (TD5766W), a replacement for the 2008-2011 Honda Accord, 2009-2011 Acura TL and 2009-2011 Acura TSX when the original bushing has cracked or worn. It installs in the front upper control arm as a direct-fit replacement for the listed applications (see the "Vehicles it fits" section for the full engine list).
Delphi draws on its OE expertise for this aftermarket bushing, running extensive dimensional and material analysis so the part matches the original closely. Delphi validates its parts to the extreme, exposing them to temperatures below -40°C and above 120°C plus 720 hours of salt spray.
A worn control arm bushing can allow the control arm to shift, producing clunks, vibration and imprecise steering; if a failed bushing is the cause, this replaces it.
Interchange: GS60471 · MS60471
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What vehicles does the Delphi TD5766W bushing fit?
It's a direct-fit replacement for the 2009-2011 Acura TL, 2009-2011 Acura TSX and 2008-2011 Honda Accord. Check the "Vehicles it fits" section to confirm the engine for your vehicle.
Where is this suspension control arm bushing located?
It fits the front upper control arm. It cushions the connection between the control arm and the chassis, helping locate the arm and dampen road vibration.
What are the signs this control arm bushing may need replacement?
Common signs include clunking over bumps, steering that feels loose or imprecise, extra vibration, and uneven tire wear. Diagnose the cause before replacing, as other parts can produce the same symptoms.
Does the Delphi bushing come with installation accessories?
Yes. Delphi includes the necessary accessories for a complete job. Consult the vehicle service information for the correct torque values and procedure.
How is this bushing tested for durability?
Delphi validates it to OE performance targets, exposing parts to temperatures below -40°C and above 120°C along with 720 hours of salt spray, plus dimensional and material analysis.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.