Keep your suspension tight and tracking straight with the Delphi Suspension Control Arm TC2143, a direct-fit replacement for the 2003-2010 Saab 9-3. This is the rear upper rearward arm, locating the suspension and helping maintain proper wheel alignment. If a worn 2003-2010 Saab 9-3 control arm or ball joint is behind clunking over bumps or uneven tire wear, this Delphi unit replaces it.
- OE-derived engineering: Delphi applies its OE expertise to the aftermarket line, testing to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for close OE compatibility.
- Verified integrity: Undergoes 100% crack detection and ultrasonic flaw detection to ensure materials match OE specifications.
- Consistent build: Robot welding delivers consistent performance and quality.
- Machined ball studs: Ball studs are machined to micron tolerances for durability and smooth joint operation.
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Interchange: 102-7920 · 523-016 · 502-1353 · 13 105 744 · 13 230274
1027920 · 523016 · 5021353 · 13105744 · 13230274 · 51748740 · 51783009 · 51803162 · CA36516 · CA36516PR · CK640742 · K640742 · RK640742 · FA3441 · CMS101056 · GS101056 · MS101056 · 423008 · 423033 · 423035 · 13204115
This part cross-references / interchanges with the following part numbers:
102-7920, 523-016, 51748740, 51783009, 51803162, CA36516, CA36516PR, CK640742, K640742, RK640742, FA3441, CMS101056, GS101056, MS101056, 423008, 423033, 423035, 502-1353, 13 105 744, 13 230274, 13204115
Frequently Asked Questions
What vehicles does the Delphi TC2143 control arm fit?
It is a direct-fit replacement for the 2003-2010 Saab 9-3. See the "Vehicles it fits" section to confirm the correct engine and configuration for your vehicle.
What position is this control arm?
This is the rear upper rearward control arm for the listed applications.
What are the signs my control arm may need replacing?
Clunking over bumps and uneven tire wear can indicate a worn control arm or ball joint. Diagnose the cause before replacing.
Is the Delphi control arm built to OE standards?
Delphi applies its OE expertise to the aftermarket line, running 100% crack and ultrasonic flaw detection so materials match OE specifications, plus salt-spray and temperature testing.
Does this control arm have corrosion protection?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics, and the ball studs are machined to micron tolerances for smooth joint operation.
