Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1236W
$12.99
(You save)
Quiet down front sway bar rattle and keep the stabilizer bar located as it works to control body roll with the Delphi Suspension Stabilizer Bar Bushing Kit TD1236W. It's a direct-fit replacement for the front position on the 2005-2006 Nissan X-Trail, cushioning the stabilizer bar where it mounts to the chassis so the bar can twist and resist lean without metal-on-metal contact.
Delphi builds this from its OE safety technology fitted to millions of vehicles worldwide, applying that OE expertise to its aftermarket steering portfolio:
Designed to OE standards: extensive dimensional and material analysis targets close compatibility between the OE and aftermarket part.
Tested to the extreme: validated below -40°C and over 120°C, with 720 hours of salt-spray exposure.
Manufactured for consistent life and to reduce noise.
Ride comfort: the bushings assist in restoring the vehicle's smooth ride.
If worn, cracked, or hardened front stabilizer bar bushings are the source of clunking or rattling over uneven pavement and vague handling, this kit replaces them. Inspect and service both sides together for even performance.
Interchange: 54613-8H318 546138H318
This part cross-references / interchanges with the following part numbers:
54613-8H318
Frequently Asked Questions
What vehicle does the Delphi TD1236W fit?
It is a direct-fit replacement for the front position on the 2005-2006 Nissan X-Trail. See the Buyer's Guide tab to confirm your exact vehicle.
Is this the same as a stabilizer bar bushing kit?
Yes. A sway bar bushing kit is also called a stabilizer bar bushing kit; the two names refer to the same part.
What does a sway bar bushing do?
It cushions the stabilizer bar where it mounts to the chassis, letting the bar twist to resist body roll without metal-on-metal contact, which helps reduce noise.
What are signs these bushings may need replacing?
Worn, cracked, or hardened bushings can cause clunking or rattling over bumps and vague handling. Diagnose the cause before replacing, as other parts can produce similar symptoms.
Has this kit been tested for durability?
Delphi validates its bushings below -40°C and over 120°C, with 720 hours of salt-spray exposure, and manufactures them for consistent life.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1236W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
