Quiet the front-end rattle and keep the stabilizer bar located with the Delphi Suspension Stabilizer Bar Bushing Kit TD1501W. This front sway bar bushing kit drops in as a direct-fit replacement for the 2010-2016 Land Rover LR4, cushioning the front stabilizer bar where it clamps to the chassis so the bar can control body roll through corners.
Delphi OE engineering: Delphi's OE safety technology is fitted to millions of vehicles worldwide, and that expertise carries into its aftermarket steering and suspension line, with extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
- Designed to OE standards — the bushings are engineered to match the original specification.
- Built for consistent life — manufactured for consistent, repeatable service.
- Noise-reducing — manufactured to reduce noise as the bar moves.
- Tested to the extreme — validated below -40°C and above 120°C and through 720 hours of salt spray.
Worn stabilizer bushings often show up as clunking or rattling from the front over uneven roads and sloppier feel in turns; if the bushings are the cause, this kit replaces them and helps restore a smoother ride. Replace both sides together for even control.
Interchange: BSK35060 · LR018346
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
What vehicle does the Delphi TD1501W fit?
It's a direct-fit front stabilizer bar bushing kit for the 2010-2016 Land Rover LR4. See the "Vehicles it fits" section to confirm the exact fit for your vehicle.
Is this the same as a stabilizer bar bushing kit?
Yes. A sway bar bushing kit and a stabilizer bar bushing kit are the same thing — the bushings that cushion and locate the stabilizer bar where it mounts to the chassis.
What are the signs my front sway bar bushings need replacing?
Common signs include clunking or rattling from the front over bumps and a looser, less controlled feel in corners. Diagnose the cause before replacing, as other parts can produce similar symptoms.
How durable are these Delphi bushings?
Delphi validates its parts below -40°C and above 120°C and through 720 hours of salt spray, and the bushings are manufactured for consistent life.
Should I replace both sides at once?
It's best practice to replace the bushings on both sides together as a set for even, balanced roll control. Check the kit contents against what your vehicle needs.
