Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4057W
$15.99
(You save)
Quiet a clunking, rattling front sway bar and keep it located through every turn with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4057W). It's a direct-fit replacement for the 2002-2007 Jeep Liberty (see the Buyer's Guide tab for engine-level detail), cushioning the front stabilizer bar where it mounts to the chassis so the bar can control body roll without metal-on-metal noise.
Designed to OE standards: engineered to match the original front sway bar bushings for the listed application.
Built for consistent life: manufactured for consistent service life and made to help reduce noise.
Tested to the extreme: Delphi validates for temperatures below -40°C and above 120°C and exposes parts to 720 hours of salt spray, backed by extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Smoother ride: designed to help restore the vehicle's smooth ride.
Worn stabilizer bar bushings often show up as clunking or rattling over bumps and vague, loose handling in corners — if hardened, cracked, or worn front bushings are the cause, this kit replaces them.
What vehicle does the Delphi TD4057W bushing kit fit?
It's a direct-fit replacement for the front stabilizer bar bushings on the 2002-2007 Jeep Liberty. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this a front or rear sway bar bushing kit?
It is a FRONT stabilizer bar bushing kit, cushioning the front sway bar where it mounts to the chassis.
What does a stabilizer bar bushing kit do?
The bushings cushion the sway bar at its chassis mounts, letting the bar control body roll while limiting noise and metal-on-metal contact.
What are the signs my sway bar bushings need replacing?
Common signs include clunking or rattling over bumps and vague, loose handling in corners. Inspect for hardened, cracked, or worn bushings and diagnose the cause before replacing.
How is this Delphi kit tested for durability?
Delphi validates parts for temperatures below -40°C and above 120°C, exposes them to 720 hours of salt spray, and runs extensive dimensional and material analysis for OE-level compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4057W
Locate your front stabilizer bar and cut down suspension noise with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4272W). This front-to-frame bushing kit drops in as a direct-fit replacement...
Quiet a clunking, rattling front sway bar and keep it firmly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD1102W. It drops in as a direct-fit replacement for the front stabilizer...
Silence a rattling front sway bar and help keep body lean under control with the Delphi Suspension Stabilizer Bar Bushing Kit TD4122W. This front sway bar bushing kit is a direct-fit replacement for...
Quiet a clunking rear sway bar and keep it located precisely with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5606W). This kit drops in as a direct-fit replacement for the 2006-2011 Honda...
Quiet the rattle and clunk from a worn front sway bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD4253W. These front stabilizer bar bushings cushion the bar where it clamps to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
