Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4119W
$14.99
(You save)
Silence the clunks and rattles from a worn stabilizer bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4119W). It drops in as a direct-fit replacement across a broad range of Ford trucks and vans — including the 1980-1991 F-150, 1980-1996 F-250, 1987-1989 Ranger, 1980-1996 Bronco, and the 1975-1991 E-150/E-250/E-350 Econoline — with 19 applications in all; see the Buyer's Guide tab for the full list. The catalog lists both FRONT and REAR positions, so confirm which location your vehicle uses before ordering.
OE-standard design: Delphi bushings are engineered to OE standards, drawing on Delphi's OE safety technology fitted to millions of vehicles worldwide.
Consistent life: manufactured for consistent service life and to help reduce noise.
Validated durability: Delphi tests to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
The bushings cushion the stabilizer bar where it mounts, limiting bar movement and helping restore a smooth ride. If cracked or worn bushings are the cause of clunking, rattling, or looseness over bumps, this kit replaces them.
The bushings cushion the stabilizer bar where it mounts to the chassis, limiting bar movement and helping reduce noise. Worn bushings let the bar shift, which can allow it to knock.
Is this the same as a sway bar bushing kit?
Yes. A stabilizer bar is commonly called a sway bar, so this is also known as a sway bar bushing kit. Both names refer to the same component.
Is this a front or rear bushing kit?
The catalog lists both FRONT and REAR positions across the covered applications. Confirm which location your specific vehicle uses before ordering.
What are the signs these bushings may need replacing?
Clunking or rattling over bumps, a loose or vague feel through corners, and cracked, dried, or worn rubber at the stabilizer bar mounts are common signs the bushings may need replacing.
Will this kit fit my vehicle?
It's a direct-fit replacement for 19 Ford truck and van applications, including F-150, F-250, F-350, Bronco, Ranger, and E-Series Econoline models. Check the Buyer's Guide tab for the full list.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4119W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
