Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4161W
$10.99
(You save)
Keep the front stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4161W). This stabilizer bar bushing kit is a direct-fit replacement for the 2005-2012 Ford Escape and 2005-2011 Mercury Mariner, cradling the front sway bar where it mounts to the frame so the bar can twist under cornering loads while damping road noise.
Designed to OE standards: built using Delphi's dimensional and material analysis for close compatibility between the OE and aftermarket part.
Manufactured for consistent life: made for dependable, repeatable performance.
Manufactured to reduce noise: helps quiet the front stabilizer bar mounting points.
Validated to the extreme: Delphi tests below -40°C and over 120°C and through 720 hours of salt spray.
The front sway bar bushings let the stabilizer bar rotate at its frame mounts while helping control body lean. Signs the bushings may need replacing include clunking or rattling from the front over bumps and increased body roll in turns. If worn bushings are the cause, these are designed to assist in restoring the vehicle's smooth ride.
What vehicles does the Delphi TD4161W bushing kit fit?
It is a direct-fit replacement for the 2005-2012 Ford Escape and 2005-2011 Mercury Mariner. See the Buyer's Guide tab to confirm your exact vehicle.
What does a sway bar bushing kit do?
These bushings cushion the front stabilizer bar where it mounts to the frame, letting the bar twist under load to help control body roll while damping noise at the mounting points.
How do I know if my stabilizer bar bushings are worn?
Common signs include clunking or rattling from the front over bumps and increased body lean in turns. Diagnose the cause before replacing, as other suspension parts can produce similar symptoms.
Where does this kit mount on the vehicle?
It serves the front stabilizer bar at its frame mounting points (front to frame).
Is this part built to withstand harsh conditions?
Delphi validates its parts below -40°C and over 120°C and through 720 hours of salt spray, and the bushings are designed to OE standards and manufactured for consistent life.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4161W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
