Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4165W
$10.99
(You save)
Quiet a clunking, rattling rear sway bar and keep it located the way it should be with the Delphi Suspension Stabilizer Bar Bushing Kit TD4165W. This rear stabilizer bar bushing kit drops in as a direct-fit replacement for the 2002-2006 Nissan Altima and the 2004-2008 Nissan Maxima, cushioning the rear stabilizer (sway) bar where it clamps to the chassis so the bar can twist and resist body roll without metal-on-metal contact.
Delphi builds on the OE safety technology fitted to millions of vehicles worldwide, applying that expertise to its aftermarket steering and suspension range.
Built to OE standards: designed to match the original bushings through Delphi's dimensional and material analysis for close OE-to-aftermarket compatibility.
Tested to the extreme: validated below -40°C, above 120°C, and through 720 hours of salt spray.
Consistent life: manufactured for consistent service and to reduce noise.
Smoother ride: helps restore the vehicle's smooth ride when worn bushings are the cause.
If worn or cracked bushings are behind the noise and sloppy handling, this kit replaces them.
What is a stabilizer bar bushing kit and what does it do?
It's the set of bushings that clamp the rear stabilizer (sway) bar to the chassis, letting the bar twist to resist body roll while cushioning it so there's no metal-on-metal contact or noise.
Which vehicles does the Delphi TD4165W fit?
It's a direct-fit replacement for the 2002-2006 Nissan Altima and the 2004-2008 Nissan Maxima. Check the Buyer's Guide tab to confirm your exact vehicle.
Is this for the front or rear sway bar?
This kit is cataloged for the rear stabilizer bar position on the listed applications.
What are signs my sway bar bushings may need replacing?
Common signs include clunking or rattling from the rear over bumps, increased body roll in turns, and cracked or worn-looking bushings. Diagnose the cause before replacing.
How is the Delphi bushing kit tested for durability?
Delphi validates these bushings below -40°C, above 120°C, and through 720 hours of salt spray, using dimensional and material analysis for close OE compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4165W
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
Quiet a clunking rear sway bar and keep it precisely located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD935W). This rear kit drops in for a wide range of BMW models, including the...
Quiet down clunks and steady the front sway bar with the Delphi Suspension Stabilizer Bar Bushing Kit TD5755W, a direct-fit replacement for the 2002-2006 Nissan Sentra. These front stabilizer bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
