Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD994W
$13.99
(You save)
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front suspension on the 2007-2011 Hyundai Accent, 2006-2011 Kia Rio, and 2006-2010 Kia Rio5. These bushings cushion the front stabilizer (sway) bar against the chassis, controlling its movement and damping the metal-on-metal noise that develops as the original bushings wear, crack, or compress.
Designed to OE standards: Delphi applies its OE steering-and-suspension expertise to the aftermarket, with extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: validated to withstand temperatures below -40°C and over 120°C, plus 720 hours of salt-spray exposure.
Manufactured for consistent life: built to deliver consistent service and to help reduce noise.
Smoother ride: designed to help restore the vehicle's smooth ride.
If worn front sway bar bushings are the source of your clunk or rattle over bumps, this kit replaces them.
It replaces the front stabilizer (sway) bar bushings, which cushion the bar against the chassis, control its movement, and dampen the noise that develops as the originals wear or crack.
What vehicles does this fit?
It's a direct-fit replacement for the 2007-2011 Hyundai Accent, 2006-2011 Kia Rio, and 2006-2010 Kia Rio5. See the Buyer's Guide tab to confirm your exact vehicle and engine.
Is this the same as a stabilizer bar bushing kit?
Yes. A sway bar bushing kit is also called a stabilizer bar bushing kit — the sway bar and stabilizer bar are the same component, so the names are interchangeable.
Does this fit the front or rear?
This kit is cataloged for the FRONT suspension on the listed applications.
What are signs the bushings may need replacing?
A clunk, knock, or rattle from the front over bumps and a looser-feeling front end can be signs of worn sway bar bushings. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD994W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking rear sway bar and keep it precisely located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD935W). This rear kit drops in for a wide range of BMW models, including the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
