Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4227W
$14.99
(You save)
Quiet a clunking sway bar and keep it firmly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4227W). This front-to-frame kit cushions the stabilizer bar where it mounts to the frame, letting the bar pivot while helping the suspension control body lean through turns. It installs as a direct-fit replacement for the listed applications: the 1999-2004 Chevrolet Tracker, 1999-2005 Suzuki Grand Vitara, 2002-2006 Suzuki XL-7, and 1999-2004 Suzuki Vitara — see the Buyer's Guide tab for engine-level details.
Designed to OE standards: built on Delphi's OE expertise, applied from safety technology fitted to millions of vehicles worldwide to its aftermarket steering portfolio.
Tested to the extreme: withstands temperatures below -40°C and above 120°C and endures 720 hours of salt spray, backed by extensive dimensional and material analysis for close OE-to-aftermarket compatibility.
Consistent, quieter service: manufactured for consistent life and to reduce noise as the bar works.
Ride comfort: designed to help restore the smooth ride of the vehicle.
If worn or cracked stabilizer bar bushings are behind a clunk, rattle, or extra body roll, this stabilizer bar bushing kit replaces them.
It cushions the stabilizer bar where it mounts front-to-frame, letting the bar pivot while helping the suspension resist body lean during cornering.
Which vehicles does the TD4227W fit?
It's a direct-fit replacement for the 1999-2004 Chevrolet Tracker, 1999-2005 Suzuki Grand Vitara, 2002-2006 Suzuki XL-7, and 1999-2004 Suzuki Vitara. Check the Buyer's Guide tab to confirm your vehicle.
What are signs my stabilizer bar bushings may need replacing?
Clunking or rattling from the suspension, added body roll in turns, or visibly cracked and worn bushings can be signs. Diagnose the cause before replacing.
Is this kit tested for durability?
Delphi tests these bushings to withstand temperatures below -40°C and above 120°C plus 720 hours of salt spray, and they're designed to OE standards.
Where do these bushings mount?
They mount the stabilizer bar to the frame in the front-to-frame position, isolating and locating the bar as the suspension moves.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4227W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
