Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4242W
$14.99
(You save)
Quiet a rattling, clunking front sway bar and firm up body roll with the Delphi Suspension Stabilizer Bar Bushing Kit TD4242W. This front stabilizer bar bushing kit drops in as a direct-fit replacement for the 1998-2000 Lexus GS300 and 1998-2000 Lexus GS400 — see the Buyer's Guide tab for engine-level details. The stabilizer (sway) bar bushings cradle the front bar where it mounts to the chassis, letting it twist to control body lean while dampening road noise and metal-on-metal contact; worn bushings are a common source of a clunk or knock over bumps and during cornering.
Built to OE standards: Delphi applies its OE safety expertise to its aftermarket steering and suspension portfolio.
Extreme-condition tested: validated below -40°C and above 120°C and through 720 hours of salt-spray exposure.
Consistent service life: manufactured for consistent life and to reduce noise.
Smooth ride: dimensional and material analysis helps match OE fit to restore the vehicle's smooth ride.
Inspect and replace worn bushings in pairs for balanced handling if a failed bushing is the cause of your front-end noise.
What vehicles does the Delphi TD4242W bushing kit fit?
It is a direct-fit replacement for the 1998-2000 Lexus GS300 and 1998-2000 Lexus GS400. Check the Buyer's Guide tab to confirm the fit for your vehicle.
Is this a front or rear kit?
This is a front stabilizer bar bushing kit — it services the front sway bar mounting bushings.
What does a stabilizer bar bushing do?
It cushions the front sway bar where it mounts to the chassis, letting the bar twist to limit body roll while dampening noise and vibration.
What are signs these bushings may need replacing?
A clunk or knock over bumps and during cornering, plus increased body lean, can be signs of worn bushings. Diagnose the cause before replacing.
Should I replace the bushings in pairs?
Yes, replacing both sides together is recommended for balanced, even handling if worn bushings are the cause of your front-end noise.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4242W
Quiet a clunking front sway bar and keep it located as it works with the Delphi Suspension Stabilizer Bar Bushing Kit TD790W. These front stabilizer bar bushings cushion the bar where it mounts to...
Quiet down front-end rattle and keep the stabilizer bar located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4112W). These front sway bar bushings cushion the stabilizer bar where it...
Quiet the clunks and rattles from a worn front stabilizer bar and keep the anti-roll system tied down tight with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4763W). It drops in as a...
Quiet down front-end rattle and keep the stabilizer bar located with the Delphi Suspension Stabilizer Bar Bushing Kit TD5760W. These front sway bar bushings cushion the bar where it mounts to the...
Suspension Stabilizer Bar Bushing KitDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
