Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4245W
$11.99
(You save)
Quiet the rattles and keep the rear stabilizer bar located precisely with the Delphi Suspension Stabilizer Bar Bushing Kit TD4245W, a direct-fit replacement for the 2000-2002 Mazda 626 (see the Buyer's Guide tab for engine-level fitment). These rear-position bushings cradle the stabilizer (sway) bar where it mounts to the chassis, letting the bar pivot as the suspension works while helping control body roll and dampening the metallic clunks and rattles that worn, cracked rubber can transmit over the road.
Built to OE standards: Delphi engineers these bushings to match the original component, drawing on OE expertise applied across its aftermarket steering and suspension portfolio.
Extreme validation: Delphi parts are tested below -40°C and above 120°C and endure 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
Consistent life & noise control: manufactured for consistent service life and to reduce noise.
Ride quality: designed to help restore the vehicle's smooth ride when worn bushings are the cause.
If dried, split, or noisy stabilizer bar bushings are behind rear-end clunking or excess body roll, this kit replaces them. Replace both sides together for balanced handling.
What vehicle does the Delphi TD4245W bushing kit fit?
It is a direct-fit replacement for the 2000-2002 Mazda 626. Check the Buyer's Guide tab to confirm the exact fitment for your vehicle.
Is this a front or rear stabilizer bar bushing kit?
This is a rear-position stabilizer bar bushing kit. It cradles the rear sway bar where it mounts to the chassis.
What is a stabilizer bar bushing kit and what does it do?
It mounts the stabilizer (sway) bar to the chassis and lets it pivot as the suspension moves, helping control body roll while reducing noise and vibration.
What are signs these bushings may need replacing?
Clunking or rattling from the rear, increased body roll in turns, and cracked, dried, or split rubber are common signs. Diagnose the cause before replacing.
Should I replace both sides at once?
Yes, replacing the bushings on both sides together is recommended for balanced, even handling.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4245W
Quiet a rattling rear anti-roll bar and keep it located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD972W). This rear-position kit is a direct-fit replacement for the 2000-2004...
Quiet the clunks and rattles from a worn front stabilizer bar and keep it firmly located to the chassis with the Delphi Suspension Stabilizer Bar Bushing Kit TD1645W. These are the front-to-frame...
Quiet front-end clunks and keep the sway bar securely located with the Delphi Suspension Stabilizer Bar Bushing Kit TD4145W. These front-to-frame bushings cushion the sway bar where it mounts to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
