Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4250W
$14.99
(You save)
Keep your front sway bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit TD4250W. These front stabilizer bar bushings cushion the bar where it mounts to the chassis, letting it resist body roll while damping the metal-on-metal contact that leads to clunks and rattles. It's a direct-fit replacement for the 1995 Toyota 4Runner and the 2001-2004 Toyota Tacoma — see the Buyer's Guide tab for engine-level fitment.
Built to OE standards: Delphi applies its OE engineering expertise to its aftermarket steering and suspension range, with dimensional and material analysis targeting close compatibility between the OE and aftermarket part.
Tested to the extreme: withstands temperatures below -40°C and above 120°C and endures 720 hours of salt spray.
Manufactured for consistent life and to reduce noise.
Ride quality: designed to help restore the vehicle's smooth ride when worn bushings are the cause.
Worn stabilizer bar bushings are a common source of front-end noise and vague handling; if the original bushings are cracked, dried out, or hardened, this kit replaces them.
It replaces the front stabilizer (sway) bar bushings that cushion the bar at its chassis mounts, letting the bar resist body roll while damping the metal-on-metal contact that causes clunks and rattles.
What vehicles does the TD4250W fit?
It's a direct-fit replacement for the 1995 Toyota 4Runner and the 2001-2004 Toyota Tacoma. Check the Buyer's Guide tab for engine-level fitment details.
What are the signs my sway bar bushings may need replacing?
Common signs include front-end clunking or rattling over bumps, vague or loose handling, and bushings that are visibly cracked, dried out, or hardened. Diagnose the cause before replacing.
Is this bushing kit built for durability?
Delphi manufactures these bushings for consistent life and tests them below -40°C, above 120°C, and through 720 hours of salt spray for OE-level performance.
Are these front or rear bushings?
This kit is for the FRONT stabilizer bar position on the listed applications.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4250W
Quiet front-end clunks and keep the sway bar securely located with the Delphi Suspension Stabilizer Bar Bushing Kit TD4145W. These front-to-frame bushings cushion the sway bar where it mounts to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
