Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4628W
$16.99
(You save)
Cut down clunks and rattles from a worn stabilizer bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD4628W. These bushings cushion the front sway bar where it clamps to the chassis, locating the bar and damping vibration so the suspension can control body roll through turns. This kit is a direct-fit replacement for the front position on the 2000-2002 Mazda 626 — see the Buyer's Guide tab for engine-level fitment.
Designed to OE standards: Delphi bushings are engineered to OE standards, drawing on the same expertise fitted to millions of vehicles worldwide.
Extreme validation: parts are tested from below -40°C to over 120°C and exposed to 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
Consistent life: manufactured for consistent service life and to reduce noise.
Smooth ride: designed to help restore the smooth ride of the vehicle.
Cracked, dry-rotted, or worn sway bar bushings can cause clunking over the front axle, excess body sway, and imprecise handling — if the bushings are the cause, this kit replaces them.
What is the Delphi TD4628W stabilizer bar bushing kit?
It is a front sway bar (stabilizer bar) bushing kit that cushions and locates the stabilizer bar where it mounts to the chassis, damping vibration and helping control body roll.
Does this kit fit my vehicle?
It is a direct-fit replacement for the front position on the 2000-2002 Mazda 626. Check the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
What are signs my sway bar bushings need replacing?
Clunking or rattling over bumps from the front, increased body sway in turns, and looser handling. Have the cause diagnosed, since these signs can have other sources.
Which numbers does this kit interchange with?
101-6187, 531-989, GE4T-34-156, BSK65109, BSK65109PR, MK90629, and JBU1064.
How are Delphi bushings tested?
Delphi tests parts from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for OE-to-aftermarket compatibility.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD4628W
Quiet down front-end rattle and keep the front stabilizer bar located precisely with the Delphi Suspension Stabilizer Bar Bushing Kit TD4050W. It installs as a direct-fit replacement for the front...
Quiet stabilizer-bar rattle and help keep the rear sway bar properly located with the Delphi Sway Bar Bushing Kit TD922W, a rear-position replacement cataloged for the 2006-2011 Land Rover Range...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Silence the clunks and rattles from a worn stabilizer bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit (TD4119W). It drops in as a direct-fit replacement for many Ford trucks and vans,...
Help quiet a clunking, rattling front stabilizer bar and keep it located to the frame with the Delphi Suspension Stabilizer Bar Bushing Kit (MPN TD1676W). This sway bar bushing kit mounts in the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
