Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5072W
$8.99
(You save)
Cut the clunks and rattles from a worn stabilizer bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD5072W. This kit installs at the rear-to-frame position, cushioning the stabilizer (sway) bar where it clamps to the frame so the bar can control body roll while damping road noise. It drops in as a direct-fit replacement for the 2011-2013 Chrysler 200, 2007-2010 Chrysler Sebring, and 2008-2013 Dodge Avenger.
Designed to OE standards: Delphi applies its OE steering and suspension expertise to the aftermarket, using dimensional and material analysis to keep the aftermarket part close to the original.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
Built for consistent life: manufactured for consistent performance and to help reduce noise.
Smoother ride: designed to help restore the vehicle's smooth ride when worn bushings are the cause of harshness.
Also listed as a stabilizer bar bushing kit. If cracked, deteriorated, or noisy bushings at the rear-to-frame mount are behind your sway bar clunk, this kit replaces them.
What is a stabilizer bar bushing kit and what does it do?
It's the set of bushings that cushion the stabilizer (sway) bar where it mounts to the vehicle. They locate the bar so it can control body roll while damping vibration and road noise.
Where does this kit mount?
This kit fits the rear-to-frame position, cushioning the stabilizer bar where it clamps to the frame.
Which vehicles does the TD5072W fit?
It's a direct-fit replacement for the 2011-2013 Chrysler 200, 2007-2010 Chrysler Sebring, and 2008-2013 Dodge Avenger. Check the Buyer's Guide tab to confirm your vehicle.
What are the signs my sway bar bushings may need replacing?
Clunking or rattling over bumps, a knocking sound during cornering, or cracked and deteriorated bushings. Diagnose the source first, since other suspension parts can cause similar noises.
How is this Delphi bushing kit tested?
Delphi validates the parts below -40°C and above 120°C and exposes them to 720 hours of salt spray, backed by dimensional and material analysis against the original.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5072W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
Quiet a clunking front sway bar and keep the stabilizer bar properly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD994W). It drops in as a direct-fit replacement for the front...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
