Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD545W
$14.99
(You save)
Keep your front sway bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit TD545W. These front stabilizer bar bushings cushion the bar where it mounts to the chassis, helping control body roll and reduce noise, and they install as a direct-fit replacement on the 1997-2001 Cadillac Catera (see the Buyer's Guide tab for engine-level fitment). Delphi applies its OE engineering expertise to its aftermarket steering and suspension portfolio, with parts validated through extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to the extreme: withstands temperatures below -40°C and above 120°C and is exposed to 720 hours of salt spray.
Designed to OE standards: Delphi bushings are engineered to match OE requirements.
Consistent life: manufactured for consistent, repeatable service life.
Quieter operation: manufactured to reduce noise and assist in restoring the vehicle's smooth ride.
Worn stabilizer bar bushings can allow the front bar to shift in its mounts, producing clunks or rattles over bumps and reduced stability through turns. If deteriorated bushings are the cause, this kit replaces them.
Interchange: 90445625 · K200062 · JBU2042
This part cross-references / interchanges with the following part numbers:
90445625, K200062, JBU2042
Frequently Asked Questions
What vehicle does this bushing kit fit?
It is a direct-fit replacement for the 1997-2001 Cadillac Catera. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
What position is this kit for?
These are front suspension stabilizer bar bushings, mounting the front sway bar to the chassis.
What does a stabilizer bar bushing do?
It cushions the stabilizer bar where it attaches to the chassis, helping control body roll and reduce noise while allowing the bar to work as intended.
What are signs these bushings may need replacing?
Clunks or rattles from the front over bumps and reduced stability through turns can indicate worn bushings. Diagnose the cause before replacing.
Are these built to OE standards?
Yes. Delphi bushings are designed to OE standards and validated through dimensional and material analysis, including salt-spray and extreme-temperature testing.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD545W
Suspension Stabilizer Bar Bushing KitDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests...
Suspension Stabilizer Bar Bushing KitDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
