Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD1634W
Quiet the clunks and rattles from a worn rear sway bar mount with the Delphi Suspension Stabilizer Bar Bushing Kit TD5539W. It fits the rear position on the 2005-2010 Cadillac STS, cushioning the stabilizer bar where it mounts so the bar can twist and control body roll without metal-on-metal noise. Delphi applies its OE engineering to its aftermarket steering and suspension line, and this kit is built to the same standard.
Signs the original bushings may need replacing include a clunk or rattle over bumps and through corners, or added body roll from a loose stabilizer bar. If worn bushings are the cause, this kit replaces them.
Interchange: 19365822 · 19465237 · K201546 · MS504319
This part cross-references / interchanges with the following part numbers:
What vehicle does the TD5539W kit fit?
It is a direct-fit replacement for the rear position on the 2005-2010 Cadillac STS. See the "Vehicles it fits" section to confirm your exact vehicle.
Is this a front or rear kit?
This is a rear stabilizer bar bushing kit for the listed application.
What does a sway bar bushing do?
It cushions the stabilizer bar where it mounts to the chassis, letting the bar twist to control body roll while limiting noise and movement.
What are the signs my stabilizer bar bushings are worn?
Common signs are a clunk or rattle over bumps and in corners, and increased body roll from a loose bar. Diagnose the cause before replacing.
Is this kit tested for durability?
Yes. Delphi validates this part below -40°C, above 120°C, and through 720 hours of salt spray, and manufactures it for consistent service life.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.