Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5660W
$17.99
(You save)
Quiet a clunking rear stabilizer bar and keep it firmly located with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5660W). It drops in as a direct-fit replacement for the 2001-2007 Toyota Sequoia — see the Buyer's Guide tab for engine-specific coverage. These bushings cushion the rear stabilizer (sway) bar where it clamps to the chassis, allowing the bar to twist and help control body roll while limiting metal-to-metal contact.
Designed to OE standards: Delphi applies its OE steering and suspension expertise to this aftermarket kit for close compatibility with the original part.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray, with extensive dimensional and material analysis.
Manufactured for consistent life and to reduce noise.
Ride quality: the bushings assist in restoring the smooth ride of the vehicle.
Cracked, split, or worn sway bar bushings are a common source of clunks and rattles from the suspension over bumps and during cornering. If worn bushings are the cause, this kit replaces them.
This part cross-references / interchanges with the following part numbers:
BL740529, K201494, JBU2220, 48818-AF010
Frequently Asked Questions
What vehicle does the Delphi TD5660W bushing kit fit?
It is a direct-fit replacement for the 2001-2007 Toyota Sequoia. Check the Buyer's Guide tab to confirm engine-specific coverage for your vehicle.
What does a stabilizer bar bushing kit do?
It cushions the rear stabilizer (sway) bar where it mounts to the chassis, letting the bar twist to help control body roll while limiting noise and metal-to-metal contact.
Is this for the front or rear stabilizer bar?
This kit is cataloged for the rear stabilizer bar position on the listed application.
What are signs my sway bar bushings may need replacing?
Clunks or rattles from the suspension over bumps and during cornering are common signs. Diagnose the cause first, since other suspension parts can produce similar noises.
How is this Delphi kit tested for durability?
Delphi validates these bushings below -40°C and above 120°C and exposes them to 720 hours of salt spray, backed by extensive dimensional and material analysis.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5660W
Quiet a clunking rear sway bar and keep it located under hard cornering with the Delphi Suspension Stabilizer Bar Bushing Kit (P/N: TD4177W). This kit cushions the rear stabilizer bar where it mounts...
Keep the rear stabilizer bar located and quiet with the Delphi Suspension Stabilizer Bar Bushing Kit (TD5070W). These bushings secure the rear stabilizer bar to the frame, cushioning it against the...
Quiet a clunking, knocking rear sway bar and keep the stabilizer bar located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD996W). This rear sway bar bushing kit cushions the bar...
Quiet a clunking, rattling front sway bar and help keep your Mercedes-Benz cornering flat with the Delphi Suspension Stabilizer Bar Bushing Kit TD5885W. This front-to-frame stabilizer bar bushing kit...
Quiet a clunking front sway bar and keep the stabilizer bar located where it belongs with the Delphi Suspension Stabilizer Bar Bushing Kit TD671W. These front stabilizer bar bushings cushion the bar...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
