Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5703W
$20.99
(You save)
Quiet a clunking front stabilizer bar and keep it properly located with the Delphi Suspension Stabilizer Bar Bushing Kit TD5703W. This front stabilizer bar bushing kit drops in as a direct-fit replacement for the 2005-2010 Scion tC, cushioning the sway bar where it mounts to the chassis so the bar stays cradled and body roll stays controlled. Worn bushings often show up as a clunk or rattle over bumps and through turns — if failed front sway bar bushings are the cause, this kit replaces them.
Designed to OE standards: built using Delphi's OE steering and suspension expertise for close compatibility with the original.
Manufactured for consistent life: made to deliver dependable, repeatable performance in service.
Manufactured to reduce noise: helps damp the rattle and squeak that develop as original bushings age.
Validated durability: Delphi tests parts below -40°C and above 120°C and through 720 hours of salt spray.
Delphi bushings assist in restoring the vehicle's smooth ride. Replacing both bushings together is recommended for even, balanced handling.
This part cross-references / interchanges with the following part numbers:
K201502, 4881505050, 48815-21020
Frequently Asked Questions
What vehicle does the TD5703W bushing kit fit?
It is a direct-fit replacement for the 2005-2010 Scion tC. Check the Buyer's Guide tab to confirm the fit for your exact vehicle.
Is this a front or rear stabilizer bar bushing kit?
This is a front stabilizer bar bushing kit, cataloged for the front position.
What does a sway bar bushing do?
It cushions the stabilizer bar where it mounts to the chassis, keeping the bar located and helping control body roll while damping noise.
What are the signs my sway bar bushings need replacing?
Common signs are a clunk or rattle over bumps and through turns as the bushings wear. Diagnose the source before replacing, since other suspension parts can cause similar noise.
Should I replace both bushings at the same time?
Yes, replacing both bushings together is recommended for even, balanced handling and consistent noise control.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Bushing Kit P/N:TD5703W
Quiet a rattling rear anti-roll bar and keep it located properly with the Delphi Suspension Stabilizer Bar Bushing Kit (TD972W). This rear-position kit is a direct-fit replacement for the 2000-2004...
Quiet the clunks and rattles from a worn front stabilizer bar and keep it firmly located to the chassis with the Delphi Suspension Stabilizer Bar Bushing Kit TD1645W. These are the front-to-frame...
Quiet front-end clunks and keep the sway bar securely located with the Delphi Suspension Stabilizer Bar Bushing Kit TD4145W. These front-to-frame bushings cushion the sway bar where it mounts to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
