Delphi Suspension Stabilizer Bar Link Kit P/N:TC1208
$25.99
(You save)
Reconnect the front stabilizer bar to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC1208, a front-position link kit that installs as a direct-fit replacement on the 1995-2002 Land Rover Range Rover. The link ties the front stabilizer (sway) bar to the suspension so the bar can resist body roll; worn links commonly show up as rattling or clunking from the front suspension over bumps and looser, less-controlled cornering. If a failed link is the cause of those symptoms, this kit replaces it.
OE-derived engineering: Delphi applies its OE steering and suspension expertise to the aftermarket line, backed by dimensional and material analysis for close OE-to-aftermarket compatibility. Parts are validated below -40°C, above 120°C, and through 720 hours of salt spray.
Fatigue tested: the sway bar links are fatigue tested to guard against failure.
Ultrasonic molding: used in manufacturing to help prevent future weld breakage.
Micron-tolerance machining: supports durability and smooth joint operation.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance.
Fits the 1995-2002 Land Rover Range Rover; see the Buyer's Guide tab for engine-level detail.
It connects the front stabilizer (sway) bar to the suspension so the bar can resist body roll and help stabilize the vehicle during cornering and over uneven surfaces.
What vehicle does the Delphi TC1208 fit?
It is a direct-fit replacement for the 1995-2002 Land Rover Range Rover. Check the Buyer's Guide tab to confirm the application for your specific vehicle.
How do I know if my sway bar links are worn?
Signs may include rattling or clunking from the front suspension over bumps and reduced cornering control. Diagnose the cause first, since other suspension parts can produce similar symptoms.
Is this a front or rear link kit?
This is a front-position stabilizer bar link kit.
How is the TC1208 tested for durability?
Delphi fatigue tests the links, uses ultrasonic molding to help prevent future weld breakage, and validates parts below -40°C, above 120°C, and through 720 hours of salt spray.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC1208
Keep body roll in check and quiet the front suspension with the Delphi Suspension Stabilizer Bar Link Kit TC1210, the front-left link that ties the stabilizer bar to the suspension so both sides work...
Tame body roll and keep your front sway bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC7654. Cataloged for the FRONT position, it drops in as a direct-fit replacement...
Keep the stabilizer bar working with the wheel and hold body roll in check with the Delphi Suspension Stabilizer Bar Link Kit TC1590. It installs as a direct-fit replacement in the front right...
Keep the stabilizer bar tied to the suspension and tame body roll through the corners with the Delphi Suspension Stabilizer Bar Link Kit TC1350. This sway bar link connects the stabilizer bar to a...
Keep body roll in check and quiet the clunks and rattles that come from worn links with the Delphi Suspension Stabilizer Bar Link Kit (TC2592). This stabilizer bar link kit connects the stabilizer...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
