Delphi Suspension Stabilizer Bar Link Kit P/N:TC1591
$32.99
(You save)
Reconnect the front stabilizer bar to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC1591 — a direct-fit Subaru Forester stabilizer bar link kit that also serves a wide Subaru and Saab lineup. This front-position kit installs on the 1990-2004 Subaru Legacy, 1993-2007 Subaru Impreza, 1998-2002 Subaru Forester, 2000-2004 Subaru Outback, 2003-2006 Subaru Baja, and 2005-2006 Saab 9-2X. See the Buyer's Guide tab for engine-level details.
The link ties the stabilizer bar to the suspension so the bar can resist body roll; worn links commonly announce themselves with clunking or rattling over bumps and vague handling through corners. If a failed link is the cause, this kit replaces it.
OE-tested durability: Delphi's aftermarket steering parts are tested below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for OE-and-aftermarket compatibility.
Fatigue tested: validated to help avoid failure in service.
Ultrasonic molding: built to help prevent future weld breakage.
Micron-tolerance machining and anti-corrosion protection: for durability, smooth joint operation, corrosion prevention, and enhanced aesthetics.
Yes. The Delphi TC1591 is listed for the 1998-2002 Subaru Forester, along with several other Subaru models and the Saab 9-2X. Confirm your model year on the Buyer's Guide tab.
Is this a front or rear stabilizer bar link kit?
This is a front-position kit per the catalog, connecting the front stabilizer bar to the front suspension on the listed applications.
What are the signs a sway bar link may need replacing?
Common signs include clunking or rattling over bumps, knocking through corners, and vague or loose-feeling handling. Diagnose the cause before replacing, as other suspension parts can make similar noises.
Should I replace both sides at once?
Sway bar links on both sides typically wear at a similar rate, so replacing the left and right together is recommended for balanced, even handling.
What does the anti-corrosion protection do?
Delphi applies anti-corrosion protection to each part for corrosion prevention and enhanced aesthetics, and the links are machined to micron tolerances for smooth joint operation.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC1591
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Keep your rear stabilizer bar tied firmly to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2919. This rear-position sway bar link kit drops in as a direct-fit replacement for...
Tie the stabilizer bar back to the suspension and quiet front-end rattle with the Delphi Suspension Stabilizer Bar Link Kit TC2909. This front right sway bar link installs as a direct-fit replacement...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
