Keep your stabilizer bar working with the body and cut down on front-end rattles with the Delphi Suspension Stabilizer Bar Link Kit TC1929, cataloged for the FRONT LEFT position on the 2009 Land Rover LR3 and 2006-2013 Land Rover Range Rover Sport (see the Buyer's Guide tab for engine-level fitment). The link ties the front stabilizer bar to the suspension so the bar can resist body lean through corners.
Features:
- OE-derived engineering: Delphi applies its OE steering and suspension expertise to the aftermarket, using extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
- Extreme testing: validated below -40°C and above 120°C and exposed to 720 hours of salt spray.
- Ultrasonic-molded: built with ultrasonic molding to help prevent future weld breakage, and fatigue tested to avoid failure.
- Micron tolerances: machined to micron tolerances for durability and smooth joint operation, with anti-corrosion protection applied to each part.
Worn links often show up as knocking or rattling from the front suspension over bumps and vague handling through corners; if a failed link is the cause, this replaces it.
Interchange: 101-7110 · 606.22004 · LA-L126 · 545-1809 · RBM 500150
1017110 · 60622004 · LAL126 · 5451809 · RBM500150 · LS13041 · SL35001 · K750251 · SL916 · MS10885 · MS10886 · JTS1255
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What is the Delphi TC1929 and where does it fit?
It's a front left suspension stabilizer bar link for the 2009 Land Rover LR3 and 2006-2013 Range Rover Sport. Check the Buyer's Guide tab for engine-level fitment.
What does this stabilizer bar link kit do?
It connects the front stabilizer (sway) bar to the suspension, letting the bar resist body lean and limit roll when the vehicle corners.
What are the signs my sway bar link may need replacing?
Knocking or rattling from the front suspension over bumps and a looser feel through corners. Diagnose the cause first, since other worn parts can make similar noises.
How is this link protected against wear and corrosion?
It's built with ultrasonic molding to help prevent weld breakage, fatigue tested, and finished with anti-corrosion protection for corrosion prevention and appearance.
Should I replace both front links at the same time?
This part is for the front left position. Many owners replace the opposite-side link at the same time for balanced handling, though it isn't required.
Write a Review