Delphi Suspension Stabilizer Bar Link Kit P/N:TC2724
$36.99
(You save)
Tighten up your handling and restore a solid link between the stabilizer bar and suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2724. This front left link drops in as a direct-fit replacement for the 2010-2019 Ford Flex, 2013-2019 Ford Police Interceptor Sedan, 2014-2018 Ford Special Service Police Sedan, 2010-2019 Ford Taurus, 2010-2016 Lincoln MKS, and 2010-2019 Lincoln MKT. If a worn or noisy original link is the cause of clunking or rattling over bumps and vague roll control, this stabilizer bar link kit replaces it.
OE-grade validation: Delphi applies its OE steering expertise to the aftermarket, testing parts below -40°C and above 120°C and through 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Fatigue tested: links are fatigue tested to help avoid failure in service.
Ultrasonic molding: manufactured with ultrasonic molding to help prevent future weld breakage.
Precision joints: machined to micron tolerances for durability and smooth joint operation, with anti-corrosion protection applied for corrosion prevention and enhanced appearance.
It connects the stabilizer (sway) bar to the suspension, transferring load between the two so the bar can limit body roll. A worn link breaks that connection and lets the bar move freely.
What vehicles does the TC2724 fit?
It's a direct-fit replacement for the 2010-2019 Ford Flex and Taurus, 2013-2019 Police Interceptor Sedan, 2014-2018 Special Service Police Sedan, 2010-2016 Lincoln MKS, and 2010-2019 Lincoln MKT.
Which position is this link for?
This kit is cataloged for the front left position. Confirm the correct application in the Buyer's Guide for your specific vehicle.
What are signs the link may need replacing?
Clunking or rattling over bumps, loose or vague handling in turns, and visibly worn or torn joint boots can be signs a sway bar link may need replacement. Diagnose the cause before replacing.
How is this Delphi link built?
It's fatigue tested to help avoid failure, made with ultrasonic molding to help prevent weld breakage, machined to micron tolerances for smooth joint operation, and given anti-corrosion protection.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC2724
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
Keep body roll in check and quiet the rattles with the Delphi Front Suspension Stabilizer Bar Link Kit TC6540. This front sway bar link connects the stabilizer bar to the suspension so the bar can...
Keep body roll in check and restore a tight, controlled feel over uneven pavement with the Delphi Suspension Stabilizer Bar Link Kit TC2409. This kit connects the rear stabilizer bar to the...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
