Delphi Suspension Stabilizer Bar Link Kit P/N:TC8472
$17.99
(You save)
Keep your roadster's stabilizer bar tied into the suspension through every corner with the Delphi Suspension Stabilizer Bar Link Kit TC8472. It installs as the front left link kit for the 2016-2025 Mazda MX-5 Miata (All engines), reconnecting the stabilizer bar to the suspension so the bar can resist body roll and help settle the chassis during cornering. If a worn link is behind clunking or rattling over bumps and through turns, this stabilizer bar link kit replaces it.
Delphi builds this link kit on its OE steering and suspension expertise:
Extreme validation: tested below -40°C and above 120°C and exposed to 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
This part cross-references / interchanges with the following part numbers:
101-8034, SL65191, KSLF4467, N24334170, MS76884
Frequently Asked Questions
What vehicle does the Delphi TC8472 fit?
It's a front left stabilizer bar link kit for the 2016-2025 Mazda MX-5 Miata (All engines). Confirm your specifics in the Buyer's Guide tab before ordering.
What does a sway bar link kit do?
It connects the stabilizer (sway) bar to the suspension, letting the bar resist body roll and help settle the chassis during cornering.
What are signs my stabilizer bar link may need replacing?
Clunking or rattling over bumps and through turns can point to a worn link. Diagnose the cause first, since other suspension parts can make similar noises.
How is this link kit protected against corrosion?
Delphi applies anti-corrosion protection to each part, and validation includes 720 hours of salt spray along with testing below -40°C and above 120°C.
How many link kits do I need?
This listing is for one link kit, and the listed application uses one. Replace worn links as directed by the service procedure for your vehicle.
Write a Review
Delphi
Delphi Suspension Stabilizer Bar Link Kit P/N:TC8472
Keep body lean in check and quiet the clunks with the Delphi Rear Suspension Stabilizer Bar Link Kit (TC2616) — a direct-fit replacement for the 2002-2007 Mitsubishi Lancer (see the Buyer's Guide tab...
Keep your rear stabilizer bar tied firmly to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC2919. This rear-position sway bar link kit drops in as a direct-fit replacement for...
Tie the stabilizer bar back to the suspension and quiet front-end rattle with the Delphi Suspension Stabilizer Bar Link Kit TC2909. This front right sway bar link installs as a direct-fit replacement...
Tighten up front-end response and quiet the clunks with the Delphi Suspension Stabilizer Bar Link Kit TC6165. These front sway bar links connect the stabilizer bar to the suspension, transferring...
Quiet the clunks and keep the rear stabilizer bar tied to the suspension with the Delphi Suspension Stabilizer Bar Link Kit TC6526. This rear-position stabilizer bar link kit drops in as a direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
